WATTS WFC-03 HCM RF 230 Wired Heat And Cool Module For Water Heating Controller Installation Guide
- June 13, 2024
- WATTS
Table of Contents
WATTS WFC-03 HCM RF 230 Wired Heat And Cool Module For Water Heating
Controller
Product Information
Product Name| Wired Heat & cool module for Water Heating Controller
230Vac WFC-03 HCM RF 230
---|---
Manufacturer| Watts Water Technologies
Website|
https://wattswater.eu/catalog/regulation-andcontrol/watts-vision-smart-home
/rf-heat-coolmodule-for-water-heating-controller-
wfc-03-hcm/
Electrical Protection| Class II with functional earth
IP Protection| IP30
Power Supply| 230V AC
Output Maximum Load| Relay: 5A
Compatibility| Compatible with WFC-03 6Z HC RF 24 / WFC-03 6Z HC RF 230 and
WFC-03 10Z HC RF 24 / WFC-03 10Z HC RF 230
Product Usage Instructions
-
1. Make sure the power supply is connected to the module. - Use the DIP switches to configure the module settings:
| DIP switch number | Function | Value (default) |
|---|---|---|
| DIP1 | Humidity activation | OFF (Disable) |
| DIP2 | H&C switch | ON (Enable) |
| DIP3 | H&C output mode | OFF (5 minutes) |
| DIP4 | Humidity input | ON (2 seconds) |
- Connect the module to the heat pump or boiler.
- If using an RF antenna, connect it to the module (optional).
- Pairing and Reset:
- To pair, press and hold the Pairing button for 10 seconds.
- To reset, press and hold the Pairing button for 20 seconds.
- Follow the installation instructions provided in the manual for proper installation of the module.
WHAT’S INCLUDE
WALL MOUNTING
DIP switch number| Function| Value (default: OFF)|
Configuration
---|---|---|---
DIP1| Humidity activation| OFF| Disable
ON| Enable
DIP2| H&C switch| OFF| 5 minutes
ON| 2 seconds
DIP3| H&C output mode| OFF| Mode
ON| Demand
DIP4| Humidity input| OFF| Free contact input
ON| NTC sensor
Safety warnings and operating instructions
This product should be installed preferably by a qualified professional.
Subject to observation of the above terms, the manufacturer shall assume the
liability for the equipment as provided by legal stipulations. All
instructions in this Quick Installation Guide should be observed when working
with the controller. Failures due to improper installation, improper use or
poor maintenance are voiding manufacturer liability. Any attempt to repair
voids the responsibility and the obligation to guarantee and replacement from
the manufacturer.
WIRING
DIMENSION
SPECIFICATION
Watts Electronics S.A.S.
B.P. N°10 – Z.A. des Tourettes • 43800 ROSIERES • France
Tél. +33 (0)4 71 57 40 49
Fax. +33 (0)4 71 57 40 90
Sales-rosieres@wattswater.com
www.wattswater.fr
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>