8BitDo Ultimate C Bluetooth Controller Instruction Manual
- June 13, 2024
- 8Bitdo
Table of Contents
8BitDo Ultimate C Bluetooth Controller
Ultimate C Bluetooth Controller
- Press the home button to turn on the controller.
- Hold the home button for 3 seconds to turn off the controller.
- Hold the home button for 8 seconds to force the controller off.
Switch
- System requirement: Switch 3.0.0 or above.
- NFC scanning, IR camera, HD rumble, and notification LED are not supported.
Bluetooth connection
- Press the home button to turn on the controller.
- Hold the pairing button for 3 seconds to enter its pairing mode, the status LED will start to blink rapidly. (This is required for the very first time only)
- Go to your Switch settings–Controllers and Sensors–Change grip/order, then wait for the connection.
- The status LED will remain solid when the connection is successful.
Wired connection
- Please ensure the [Pro Controller Wired Communication] is enabled in the system setting.
- Connect the controller to the Switch via a USB cable and wait until the controller is recognized by the system to play.
Battery
16 hours of play time with a 480 mAh built-in lithium battery pack,
rechargeable with 2 hours charging time.
status – LED indicator
- low battery red LED blinks
- battery charging ed LED stays solid
- battery full charged rred LED turns off
- The controller will automatically shut down if there is no connection within 1 minute after startup or no activity within 15 minutes after connection.
- The controller will not shut down when it’s over wired connection.
Support
Please visit support.8bitdo.com for further
information & additional support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>