FLOTIDE SMD2835 1 Inch Fitting LED Pool Light Instruction Manual

FLOTIDE SMD2835 1 Inch Fitting LED Pool Light

Product Information

This product is a LED bulb that is available in three variants: white, white and blue, and RGB. The bulb has a continuous operation life of 30,000 hours and has a power factor of 90% (75% for power 10W). The protection degree of the bulb is IP68 and it has a chromatic index CRI of 85%. The bulb requires a standard input voltage of 12V (AC/DC for single color, AC only for RGB color).

Variants

• WHITE: Available in 252 LED (18W, 1890lm), 333 LED (24W, 2200lm), and 441 LED (35W, 2980lm).
• WHITE/BLUE: Available in 252 LED (18W, 1180lm), 333 LED (24W, 1480lm), and 441 LED (35W, 2070lm).
• RGB: Available in 252 LED (18W, 780lm), 333 LED (24W, 980lm), and 441 LED (35W, 1290lm).

Sequence

The RGB variant of the bulb has 16 programs with synchronization capability. The sequence of programs is as follows:

1. Evening sea: slow animation blue/red
2. Evening rivers: slow animation green/red
3. Riviera: slow animation blue/green
4. White: neutral white
5. Rainbow: slow animation in green/blue/cyan/yellow/purple/RGB/red
6. River of colors: slow animation in red/green/blue/cyan/yellow/purple/RGB ,followed by program 8
7. Disco: fast animation ,(fast-slow) followed by program5
8. Full colors: slow animation in yellow/green/cyan/blue/purple/red
9. Party: fast animation,(fast-slow) followed by program 6
10. White: sun white
11. Red: fixed color red
12. Green: fixed color green
13. Blue: fixed color blue
14. Green-blue: fixed color green/blue(cyan)
15. Red-green: fixed color red/green(yellow)
16. Blue-red: fixed color blue-red (purple)

Product Usage Instructions

Instruction & Use:

The bulb needs to be connected to a special adapter that is designed for it.

Safety Warnings

• Do not handle the bulb without ensuring that there is NO voltage supplied to it.

Maintenance & Replacement

The bulb does not require any maintenance. It is designed to be used only once, meaning that replacement is necessary if it becomes defective (repairing is impossible). To replace, unfasten the lamp from the nozzle and put a new lamp inside. Ensure the new lamp is of the same model and characteristics as the one being replaced.

Start-up

The bulb will start once it is connected to a power source of 12V (AC/DC for single color, AC only for RGB color).

Warranty

The unit meets the essential requirements of EC directives, it was also built in compliance with the WEEE directives, and complies with the requirements of European Directive 2002/95/EC(RoHS).

End-of-life care for the electrical device

The bulb must be delivered to an appropriate collection point for the recycling of electrical and electronic equipment. For more detailed information about the recycling of this product, you can contact the office of your municipality or the local waste disposal service.

Description

LED Pool light for nozzle of pool, with threaded connection for nozzles 1-1/2″ and (If with adapter) for nozzles 2” (inlet) Available in 2 size versions: with external diameter of the frame 160 mm and of 220 mm.
Available in 2 thread versions: short thread version for concrete & fiber glass pools . long thread version for .vinyl liner pools.
Available in color versions: white, white/blue and RGB (color).

Frame: Colorful plastic frame / 316Lstainless steel . Body :Anti-UV polycarbonate.
Inner: fully resin filled . The lamp is supplied with cable of 2m, 4m, 6m, 10m, 15m 20m or 30m according to the need of the user, making it possible to install multiple lamps connected to a single junction box.

Technical Features

• Standard input voltage: 12V (AC/DC for single color, AC only for RGB color)
• Use life: 30,000 hours continuous operation
• Color: White or White and Blue, or RGB (16 programs with Synchronization capability)
• Power factor: 90% (75% for power 10W).
• Protection degree: IP68
• Chromatic index CRI: 85%

Input Watt and lumen: Ø 220 mm VERSION – LED SMD2835

WHITE

WHITE/BLUE RGB

| 252 LED – 18W – 1890lm
252 LED – 18W – 1180lm252 LED – 18W – 780lm| 333 LED – 24W – 2200lm
333 LED – 24W – 1480lm
333 LED – 24W – 980lm| 441 LED – 35W – 2980lm
441 LED – 35W – 2070lm
441 LED – 35W – 1290lm
---|---|---|---

Input Watt and lumen: Ø 160 mm VERSION – LED SMD2835

WHITE WHITE/BLUE RGB| 144 LED – 10W – 1050lm
144 LED – 10W – 740lm
144 LED – 10W – 505lm| 252 LED – 18W – 1780lm
252 LED – 18W -1100lm
252 LED – 18W – 710lm|
---|---|---|---

Sequence 16 Programs of RGB LED Bulbs

1. Evening sea: slow animation blue/red;
2. Evening rivers: slow animation green/red;
3. Riviera: slow animation blue/green;
4. White: neutral white;
5. Rainbow: slow animation in green/blue/cyan/yellow/purple/RGB/red;
6. River of colors: slow animation in red/green/blue/cyan/yellow/purple/RGB ,followed by program 8;
7. Disco: fast animation ,(fast-slow) followed by program5;
8. Full colors: slow animation in yellow/green/cyan/blue/purple/red;
9. Party: fast animation,(fast-slow) followed by program 6;
10. White: sun white
11. Red: fixed color red;
12. Green: fixed color green;
13. Blue: fixed color blue
14. Green-blue: fixed color green/blue(cyan);
15. Red-green: fixed color red/green(yellow)
16. Blue-red: fixed color blue-red (purple).

Instruction & Use

• This LED pool light for nozzle is designed to be installed in most of the nozzles on the market, both with 2 ” external thread (1 ½ ” internal thread) and external 2 ½ ” thread (with 2″ internal thread) ,if use of a special adapter.
• The light should be positioned on the wall of the pool about 700 mm deep with respect to the surface of the water, in an area easily accessible for possible maintenance.
• The light can be fixed on concrete or stone wall pools, thin wall pools, fiberglass wall pools, metal wall pools, or wooden wall pools with liner.

Maintenance & Replacement

There is no maintenance required for this light. It is designed to be used only once, meaning that replacement is necessary if it becomes defective (repairing is impossible). Before any handling, ensure that there is NO voltage supplied to the lamp. To replace, unfasten the lamp from the nozzle and put a new lamp inside .

Ensure the new lamp is of the same model and characteristics as the one being replaced.

Start-up

• The lamp should only operate underwater while secured to the vertical walls of the pool. Never switch on the lamp if it is not underwater.
• In case of colored lamps, 16 pre-programmed effects and combinations may be selected using the on/off switch of your pool lights. Just switch off and switch on within 3 seconds.
• If the light is powered off for more than 20 seconds, it will keep the latest program when it is turned on again.(Memory Function)
• To achieve synchronization, confirm all lamps are installed correctly on the same switch, after they are powered off for more than 20 seconds, switch on and switch off continuously 3 times, and then finally turn them on again. They will all go to program 1. Now you can select a program for them by switch off and on within 3 seconds .(Re-set Function)
• White / blue lamps can work with white or blue light. To switch from one type to another by turn on/off.

Safety Warnings

• Don’t use electronic transformers which may damage the light. You should use industrial

frequency transformer, such as toroidal transformer and square transformer .
For your security the persons who are in charge of installation should have the required qualifications for this type of work.

• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• IEC 364-7-702 standards must be observed: SWIMMING POOLS.
• Replacement must be performed with the lamp disconnected from the electric power system.
• Do not handle any electrical components with wet feet.

Warranty

The manufacturer warrants this LED light underwater against defects in materials and workmanship for a period of two years from the date of purchase.This warranty does not cover the fixture becoming damaged due to misuse, accidental damaged, improper handling and/or installation and specifically excludes liability for direct, incidental or consequential damages.

WARNING: Frequent voltage fluctuations can irreparably damage the lamp.
If the installation must take place in areas where these changes may be frequent, a system to protect the lamps must be installed on the electric system of the pool.

The manufacturer does not guarantee lamps that have been damaged by these events.
However, faulty lamps with the following faults are not to be considered:

• Lamps with less than 500 LEDs: 3 LEDs off or less.

This defect is part of the normal operation of the lamp.

Relevant directives:
The unit meets the essential requirements of EC directives, it was also built in compliance with the WEEE directives, and complies with the requirements of European Directive 2002/95/EC(RoHS).

End-of-life care for the electrical device:

• The present product is subject to proper disposal at the time of its disposal.
• Once discarded, it must be delivered to an appropriate collection point for the recycling of electrical and electronic equipment.
• For more detailed information about the recycling of this product, you can contact the office of your municipality or the local waste disposal service.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>