LED WORLD ALED-RD12H-1W-X LED Mini Stairs Light Instruction Manual
- June 13, 2024
- LED WORLD
Table of Contents
LED WORLD ALED-RD12H-1W-X LED Mini Stairs Light
Product Information
The LED Mini Stairs Light is a compact lighting fixture designed for illuminating stairs. It is available in two models:
- Model: ALED-RD12H-1W-X (X:27K, 30K) – This model is available in single color options with a power rating of 1 watt. The X parameter can be either 27K or 30K.
- Model: ALED-RD12H-1.2W-RGB – This model is an RGB variant with a power rating of 1.2 watts.
The LED Mini Stairs Light is manufactured by LED World Lighting and can be purchased from ledworldlighting.com or ledworld.ca. For customer support, you can contact 1-800-387-4081.
Product Usage Instructions
WARNING: Use only with Class 2 Power Supply. Always connect the LED light to the power supply first and then connect the power supply to the mains. Failure to do so may cause damage to the existing diode.
Wiring Diagram
The wiring diagram for the LED Mini Stairs Light is as follows:
- Recessed Mounting
- Screw in trim
- 120V AC INPUT 100~277VAC
- G OUTPUT 12VDC V- V+
- Red Wire (V+)
- Green Wire Ground
- Case enclosure wire must be grounded
- Black Wire (V-) – Single color Stair light
- Mounting:
- Insert the light into the cut hole and screw in trim/scoop.
- Turn on the power.
- RGB
- GND
- +12V
- Optional RGB Color Controller
- R B G +12V
- Class 2 Power 12VDC
- 120V AC RGB Stair light
Please follow the above wiring diagram and instructions for proper installation and usage of the LED Mini Stairs Light. If you have any further questions or need assistance, please refer to the user manual or contact customer support.
IMPORTANT INSTRUCTIONS
CAUTION:
- Must be installed by a qualified licenced electrician
- Turn power off prior to installation
- Drill a hole 01 1/4″. Minimum recess depth required 1.14″ (29mm)
- Route the low voltage wiring through the hole
- Route the low voltage wire from the light so that they will not be damaged or pinched
- Insert the light into the hole; fiction fit light will lock in place
- Connect the light’s low voltage wiring to the class 2 LED power supply. #MD-012-060VTDHV2, #MD-012-030VTDHV2 – sold separately)
- WARNING: Use only with Class 2 Power Supply. Always connect the LED light to the power supply first and then connect the power supply to the mains. Failure to do so may cause damage to the existing diode.
MOUNTING
- Turn off the power at breaker
- Drill a 01 1/4″ hole through mounting surface, see fig 1
- Connect light to the Class 2 driver, see wiring diagram for the your model
- Insert the light into the cut hole and screw in trim/scoop.
- Turn on the power
WIRING DIAGRAM
THREE YEAR LIMITED LIGHTING WARRANTY
impied. in is mind tian he fortion or he company slimina rep ting on protest bois, is pile iny componention the boredie hostiniel aral he or anity opened er caused by buyer or alteration to the product or incorrect power supply. Factory warrantees are covered by the original manufacturer and claims must be submitted to them.
References
- LED World Canada - A Commercial LED lighting supplier
- LED World Lighting - A Commercial LED lighting supplier
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>