FIAMMA 98655Z151 Campereve Cap Road Instruction Manual

: June 13, 2024
: FIAMMA

Table of Contents

98655Z151 Campereve Cap Road
Package contents
Installation instructions
Safety instructions
Warranty Fiamma
Documents / Resources

Installation instructions for brackets

98655Z151 Campereve Cap Road

Please consult the website for instructions in the languages: NL-SV-DA-NO-FI- PT
KIT CAMPERÊVE CAP ROAD
98655Z151 F35pro
FIAMMASTORE

Package contents

Installation instructions

Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. We recommend that the installation is carried out by qualiﬁ ed personnel and in compliance with current local regulations.
ATTENTION: INSTALLATION ON FIXING KIT
The brackets must always be well-aligned to each other to avoid later problems; in case they are not, they must be properly shimmed using the spacers to ensure the alignment.
The installation of the awning can occur only when the brackets are perfectly aligned to the roof of the vehicle.

SIKA 252
Important: use of SIKA 252 adhesive is essential for ﬁ xing the bracket (brackets).

SIKA 252
Important: use of SIKA 252 adhesive is essential for ﬁ xing the bracket (brackets).

Standard delivered with the awning.

Safety instructions

Before tightening the screws, make sure that the awning position doesn’t prevent the opening of the rear door When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed. Checking that the wall/roof/rear door is sufﬁ ciently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce it these points. In the event of an accident involving the vehicle and/or the product, ensure that the product has not been damaged. In the event of damage, contact your local retailer before moving the vehicle. Fiamma declines every responsibility for any modiﬁ cation of the product that may cause damage and/ or injury to things and people.

Warranty Fiamma

In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.

https://www.fiamma.it/en/
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time,
without notice, prices, materials,
speciﬁ cations and models or to cease
production of any model.