RELIANCE 13-090 Universal USB USB C Fast Charger Socket Instruction Manual
- June 13, 2024
- RELIANCE
Table of Contents
RELIANCE 13-090 Universal USB USB C Fast Charger Socket
Product Information
- Product Name: USB/USB-C 12v Fast Charger
- Product Model : 13-090
- Recommended Installation : Professional installation is recommended. If self-installing, exercise caution, care, and patience.
- Compatibility : Designed to operate on 12 volts ONLY.
Product Usage Instructions
- Locate the desired spot on your dash panel to mount the USB/USB-C charger. Check the backside of this location for any cart harness, wires, or other obstructions before cutting.
- Using the ring nut on the backside of the USB as a template or a 1 1/8 Paddle Bit, drill a hole for your USB.
- On the backside of the USB, you will notice that the two terminals are marked (+) for Positive and (-) for Negative connections.
- Before attaching the power wires to the USB, remove the ring nut and slide it over the wires behind the mounting location. Then, attach your 12-volt wire connections to the USB as shown.
- Insert the USB into the mounting hole and secure it with the ring nut. The USB has a built-in LED backlight that signifies when it is on. If you do not have the USB connected to a switched 12v source, there is a Power Button to turn the USB on/off for constant power connections.
USB/USB-C 12v Fast Charger installation instructions
We recommend professional installation. If you choose to not have this product
installed by a professional, we highly recommend that you exercise caution,
care, and patience when installing this product.
INCLUDED WITH KIT
- USB/USB-C
- 2 x Female Spade Connectors
TOOLS NEEDED
- 1/8” Paddle Bit or Rotary Cutting Tool
Note: This USB/USB-C Charger is designed to operate on 12 volts ONLY.
- Locate the spot on your dash panel you wish to mount the USB/USB-C. Be sure to check the back side of this location for cart harness, wires, or other obstructions before cutting.
- Using the ring nut on the backside of the USB as a template or a 1 1/8” Paddle Bit, drill out the hole for your USB.
- Notice on the backside of the USB that the two terminals are marked (+) for Positive and (-) for Negative connections.
- Before attaching the power wires to the USB remove the ring nut and slide it over the wires behind the mounting location.
- Then attach your 12 volt wire connections to the USB as shown.
- Insert USB into mounting hole and secure with the ring nut.
- The USB is backlit w/LED that signifies when it is on. If you do not have the USB hooked to a switched 12v source, there is a built in Power Button to turn USB on/off for constant power connections.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>