FLOS 189 Aim Multiple Rosette Instruction Manual
- June 9, 2024
- FLOS
Table of Contents
189 Aim Multiple Rosette
Instruction Manual
INSTRUCTION FOR CORRECT INSTALLATION AND USE
WARNING!
The safety of this fitting can only be guaranteed if these instructions are
observed, during both installation and use. Please retain these instructions
safety.
REMARKS:
- When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
- The appliance may in no way be modified or tampered with, any modification may compromise safety causing the appliance to become dangerous. FLOS declines all responsibility for products that are modified.
- The multiple rose enables you to turn on five separate light fittings (the installer is asked to install a system with multiple turn-on) or simultaneous turn-on of from 2 to 5 light fittings.
- The apparatus must be installed by trained staff. If not familiar with electrical connections contact a qualified electrician.
- The symbol shown on the device indicates that the product must be thrown out in a different manner than with the urban trashes.
CLEANING INSTRUCTIONS
- Use only a soft cloth to clean the appliance, dampened with water and soap or mild cleanser if needed for resistant dirt.
- Warning: do not use alcohol or other solvents.
Pic.3E/5E/5U NOTE: Select and employ screw anchors which are suited to the surface where the appliance is to be installed.
ASSEMBLY SEQUENCE
USA Version
Fig.1U – 2U – 4 – 5U – 6U – 7U.
BLACK to BLACK (L)
WHITE to WHITE (N)
GREEN to EARTH (GND)
Fig.6U Dismount the cable lock (I) from the ceiling attachment by
unscrewing the screws; Pass the power cables from the device through the rose
(E), the cable gland (M)
( NOTE: use the correct gable gland according to the number of cables
used), the ceiling attachment (G) and the fixture plate (O); make the
electrical connections in the Junction Box then lock the power cables by
remounting the cable locks (I);
NOTE: The multiple rose enables you to turn on five separate light
fittings (the installer is asked to install a system with multiple turn-on) or
simultaneous turn-on of from 2 to 5 light fittings.
Fig.7U Fix the ceiling attachment and the fixture plate to the Junction Box with the screws (P) provided (the screws are in the box with the single device body); Remount the rose to the ceiling attachment; to adjust the height of the fitting, run the power cable through the cable glands (D) and (Q), while to adjust the tilt of the head (R) rotate the cable gland (Q) adjusting the length of the power cable at the same time.
Design Ronan & Erwan Bouroullec, 2014
flos.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>