waterpik WP-360 Water Flosser User Guide
- June 17, 2024
- Waterpik
Table of Contents
waterpik WP-360 Water Flosser
Charge Unit for 24 Hours Prior to First Use
Turn power switch OFF, plug power cord into outlet, and insert the charging cord into the unit.
Insert Tip
Select the appropriate tip and insert into the unit. Press firmly until the
tip clicks into place To remove tip, push the tip eject button.
Note: For first time use, use blue low pressure tip. To increase water
pressure , use the clear high pressure tip.
Fill the Reservoir
Unplug charging cord from unit prior to filling with water and during use.
Lift the flip top on reservoir and fill with lukewarm water. Refill as needed.
Usage
Be Sure tip is fully engaged before turning ON.
Note: OFF button is Located directly blow the ON button.
The device is only compatible with a voltage system of 120VAC , 60 hz.
Do not plug this device into a voltage system that is different.
On/off Procedure
Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. Turn unit ON.
Keep unit upright during use to ensure continuous water flow.
Technique Tips For Best Results
Aim The tip just above the gumline at a 90 degree angle.
Starting with the back teeth, follow the gumine and pause briefly between
teeth.
Continue until areas around and between teeth have been cleaned.
REGISTER YOUR PRODUCT ONLINE NOW!
Revice up to $44 in savings on the purchase of additional Waterpik®
products.
www.waterpik.com/registration
CUSTOMER SERVICES
Water Pik, Inc.
1.800.525.2772
www.waterpik.com
1730 East prospect Road, Fort Collings, Co 80553-0001 USA
@2013 Water Pik inc.
20017178-F AB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>