AGPTEK CDN-SDL01 Deck Light Blue Light User Manual
- June 13, 2024
- AGPTEK
Table of Contents
AGPTEK CDN-SDL01 Deck Light Blue Light User Manual
Please read this user manual carefully before use for proper use and keep it for further reference. Before first use, please expose the solar light to the sunlight for 6-8 hours for charging.
IMPORTANT
The charging time and charging efficiency of solar panels are subject to the weather and installation location, so it’s recommended to install the product in a place with plenty of direct sunlight.
Product overview
Specification
Solar Panel Vaterial | Monocrystalline Silicon |
---|---|
Solar Panel Power | 2V/160mA 0.32W |
Battery Capacity | 1.2V/600mAh |
Working Temperature: | —20°C-+70°C |
Charging Time | about 4.5h(Standard Light Intensity) |
Working Time | 20h |
Lamp Bead Type | F3 |
Lamp Bead Number | 6 |
Compression Resistance | <3 tons |
Waterproof Rating | IP67 |
Material | Aluminum Alloy+PC+ABS |
Working Principle
The product utilizes solar panels to collect and store solar energy, then
convert the energy into electrical energy and store it in the battery. The LED
automatically lights up at night when the light is insufficient in rainy and
foggy weather.
Installation Steps
-
Move the switch to the ON position to turn on the light.
-
Cover the 2 solar panels with your hands and check if the light is on.
-
Drill two holes in the desired locations.
-
Insert the expansion bolts, place the light and tighten with screws.
Areas Not Suitable for Installation
-
Monitoring Area: The surveillance camera has infrared rays, which will affect the solar light.
-
Area with Short Light Hours: The solar light needs to install on a place with at least about 5 hours per day of sunlight exposure.
-
Area Under Strong Light: If there are strong lights on, the solar light may think it is daytime, thus, it may not automatically light up.
-
Area Under A Shelter: Installing in the shade or other places where sunlight cannot reach will affect the charging efficiency.
Cautions
- Please place the product in a sunny place and charge it for a day if not in use for a long time. For better maintenance, it’s best to keep it in a sunny spot once every month.
- Please keep the switch ON when charging, otherwise it will not charge.
- Avoid using the product in a high temperature, humid and corrosive environment for a long time, otherwise it will affect the service life.
- The product is IP67 waterproof and can withstand rainy weather and wet environments, but cannot be soaked in water.
- Do not throw the battery into fire to avoid the risk of explosion.
Maintenance
- Please keep the solar panel clean and regularly wipe off the dust or other debris on the surface with a damp cloth. Excessive dust or debris can reduce the charging efficiency of the solar panel.
- On heavy snow days, the solar panel should be cleaned in time to avoid snow cover on the surface.
FAQ
Questions| Possible Reasons| Solutions|
---|---|---|---
| The switch is not turned ON while charging| Please keep the switch ON and
recharge|
Too close to other light sources| Cover the solar panel with your hand, if the
light is on, the solar light is working properly. Please move and install it
elsewhere.|
Bad battery
Please contact us for help|
Doesn’tlight up atnight| Check if the installation area has sufficient light
during the day| Install in a place with sunlight, at least ensure that there
is no blockage from 9:00 to 15:00 every day|
The installation area is exposed to strong light or infrared light| Please
stay away from strong light areas or infrared areas|
Short working hours| No enough sunlight due to installation in a shady place
or charging on cloudy days| is exposed in sufficient direct sunlight to
charge. In case of rainy days without sufficient sunlight, the solar light
will automatically return to the best working state after the weather clears
up and is exposed to sunlight the next day|
| Charging efficiency will be affected as solar panel is covered with dust or
debris| Clean the solar panel regularly to ensure adequate exposure to
sunlight|
Stop working after a short time (weeks/mon ths)| Not getting enough sunlight
for a long time| |
Water leaks after heavy rain or snow| Move the solar light and expose it to
direct sunlight, without being shaded.|
Bad battery
Manufacturer: Shenzhen Changdaneng Technology Co., Ltd.
Address: 4th Floor, Rongxinsheng Building, Xingui Road, Dalang Street, Longhua District, Shenzhen.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>