floorMuffler COMBOFOAM Floating Floor Instruction Manual
- June 13, 2024
- floorMuffler
Table of Contents
floorMuffler COMBOFOAM Floating Floor
Installation Instructions
-
Make sure the subfloor is structurally sound, level and is free of dust and debris.
-
Check for protruding nails and/or defects in the subfloor. If installing over concrete, the concrete must be dry with moisture emission rates that do not exceed 3 lbs. per 1000 square feet per 24 hours as measured by the Anhydrous Calcium Chloride Test.
-
Start in a corner with the tape strip side next to the wall and the overlapping film toward the open room.
-
Install ComboFoam® parallel to the wall in the opposite direction that you plan to install the flooring planks.
-
When installing the ComboFoam®, leave at least 2” going up the wall.
-
Roll out the next roll of ComboFoam® in the same manner, making sure that the foam seams are butted together.
-
Be sure to overlap only the moisture barrier lip and not the foam pad.
-
Remove the adhesive liner and adhere the foam to the film overlap.
-
Install the flooring per manufacturer’s instructions.
Customer Support
floormuffler.com
1 800 440 6008
Let’s get social
