birzman Maha Flick-It V Upright Pump Instruction Manual
- June 13, 2024
- Birzman
Table of Contents
birzman Maha Flick-It V Upright Pump
Product Information
The Flick-It is a versatile inflation tool designed for use with Presta and Schrader valves. It is compatible with valves that have a minimum diameter of 14mm (or more) for Presta valves and 4.5mm (or more) for Schrader valves.
Please note that the valve head should be parallel with the valve and pressed down completely when inserting the Flick-It. It is important to refrain from attempting to lubricate the valve during the inflation process.
The Flick-It comes with spare parts, including Rubber B, Pin, and Spring. These spare parts can be accessed by lifting the lever up to push them out for easier replacement.
When assembling the spare parts, ensure that the flatter side of Rubber B is facing outwards. Join the wider side of the spring with the pin, and then insert the pin through Rubber B. Finally, place all the parts into the housing and push down tightly.
Product Usage Instructions
- Insert the Flick-It into the valve head, ensuring it is parallel with the valve.
- Lift the lever up to inflate or access spare parts.
- Press the lever down to engage the inflation process.
- Pull the lever back to disengage after inflation or to release spare parts.
For Presta valves, please ensure that the valve head is pressed all the way down when inserted. For Schrader valves, follow the same insertion process without any additional instructions.
For additional information and support, please refer to the Flick-It Instruction Manual available at https://manual-hub.com/.
INSTRUCTION
Insert, lift the lever up, and inflate.
Press the lever down then pull back to disengage.
Caution:
- Please ensure the valve head is parallel with the valve and pressed all the way down when inserted.
- Please refrain from lubrication attempts.
Flick-It is compatible with:
Flick-It Spare Parts
Lift the lever up to push the parts out for easier access.
- Join the wider side of the springwith the pin.
- Insert the pin through Rubber B.
- Place all into the housing and push down tightly.
The flatter side of Rubber B should be facing outwards.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>