MAGNUM RTS12FD Drop Side Steps Running Boards Installation Guide

RTS12FD
MAGNUM RT STEPS

Components:

Hardware:

| M10 x 30 mm
Hex Head Bolts
Qty 12
---|---
| M8 x 25 mm
Hex Head Bolts
Qty 6
| M8 Hex Head
Nuts
Qty 6
| M10 Flat
Washers
Qty 12
| M8 Flat
Washers
Qty 12
| M8 Lock
Washers
Qty 24
| RTSPN175
Bolt/Nut Plates
Qty 6
| M8 Plastic
Push Nuts
Qty 6

Tools Required:

Torque Specifications:

For Rocker Panel Mount Installations M8 through M12 bolts and nuts are set to 15-20 ft lbs.

Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.

1. Remove all contents from the package and check stainless steel tubes for any damage. Also, verify that all components and hardware listed above are included before you begin installation.

2. Read installation manual and installation drawing completely. Understand all brackets and bolts before installation.

3. Begin installation on the drivers’s side. Front and Center Bracket Cradle face to the rear of truck and Rear Bracket Cradle faces to front of truck.
   

4. Fasten each bracket using two (2) M10 x 30MM Hex Head Bolts, two (2) M10 Flat Washers, two (2) M10 Lock Washers.
   

5. Fasten each bracket using two (2) M10 x 30MM Hex Head Bolts, two (2) M10 Flat Washers, two (2) M10 Lock Washers.
   Installing the Step Bar

6. Line up mounting points on the step bar with the mounting holes in each bracket.

7. Fasten the step bar to each bracket using one (1) RTSPN175 Bolt/Nut Plate, one (1) Plastic Push Nut, one (1) M8 Hex Head Nut, two (2) M8 Lock Washers, two (2) M8 Flat Washers and one (1) M8 x 25MM Hex Head Bolt.

8. Adjust the bars front/back and up/down to desired placement. Once you have the step positioned, tighten until the split lock washer is flat between the bolt head and flat washer. Do not over tighten.

9. When all hardware is in place, everything must be tightened. See page 1 for torque specifications. Repeat these steps for opposite side installation.
   

OPTIONAL:
If you wish to install the Front Armor Plates, begin by thoroughly cleaning the front side of the front step where the Front Armor Plate will attach.

1. Remove adhesive protection from the Front Armor Plate.
2. Carefully line up with the front side of the front step. Be careful not to let the side overhang as they could peel off over time.
   Once lined up, firmly press the Front Armor Plate on the step to ensure complete adhesion.
   Repeat these steps for opposite side.

SKU# RTS12FD
REV 2

Documents / Resources

| MAGNUM RTS12FD Drop Side Steps Running Boards [pdf] Installation Guide
RTS12FD Drop Side Steps Running Boards, RTS12FD, Drop Side Steps Running Boards, Side Steps Running Boards, Steps Running Boards, Running Boards
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>