VISUAL COMFORT IKF 5038 Aspen Large Linear Chandelier Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
Aspen Large Linear Chandelier
Instruction Manual
Item # IKF 5038
ASSEMBLY INSTRUCTIONS
Aspen Large Linear Chandelier
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install it.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver | Slotted Screwdriver | Chain Pliers |
|---|---|---|
| Slip Joint Pliers | Measuring Tape | Wire Cutters |
| Wire Strippers | Hammer | Pencil |
| Drill |
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from the canopy (E) by removing collar rings (H).
-
Using mounting plate (B) as a guide, line up with the junction box and mark anchor positions.
-
Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into holes using the hammer.
-
Install mounting plate (B) to the junction box and secure it with mounting screws (F), then secure wood screws (D) to anchors (A).
-
Install canopy (E) to collar loops (C) and secure with collar rings (H).
-
Determine desired overall length, and amount of chain (J) needed.
Shorten the chain using chain pliers. (Keep extra chain) -
Attach chain (J) to collar loops (C) and fixture loops (K) using quick links (I). Secure quick links (I).
-
Thread fixture wire and ground wire through the chain (I).
NOTE: When you reach the collar loop (C), ensure there is no tension on the wires. Cut excess wires, being sure to leave enough to reach the junction box. -
Separate two sides of the molded wire, and strip insulation on each 5/8″.
-
Loosen collar rings (H) and let canopy (E) slip down the chain (J) carefully.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (G).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (G).
-
Connect fixture hot wire (smooth with markings) to the supply hot wire (usually black) using wire nut (G).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Install canopy (E) to collar loops (C) and secure with collar rings (H).
-
Place shade (N) into the slot of bracket (P), then install hanging hooks (M) to bracket (P) and secure with screws (O).
-
Attach hanging hooks (M) to hooks on brackets (L).
-
Install light bulbs into the sockets.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>