HONDA GL1800B Junction Lead Headset Instruction Manual
- June 13, 2024
- Honda
Table of Contents
GL1800B Junction Lead Headset
Instruction Manual
INSTALLATION
INSTRUCTIONS
Accessory
JUNCTION LEAD HEADSET
P/N 08B70-MJG-670
PARTS LIST
| No. | Description | Qty |
|---|---|---|
| 1 | Junction lead headset | 1 |
| 2 | Connector holder | 1 |
| 3 | Wire tie | 1 |
| 4 | Installation Instruction URL | 1 |
| 5 | Cushion tape | 1 |
SUPPLIES REQUIRED
Marker
Ruler
Scissors
Isopropyl alcohol
Shop towel
TORQUE CHART
Refer to the Service Manual for the torque values of the removed parts.
INSTALLATION
NOTE:
- Heat the bonding surfaces with a hair dryer if the ambient air temperature is below 70°F (21°C).
- The adhesive reaches full strength in 72 hours. Wait at least 24 hours before riding your motorcycle.
- Disconnect the negative (-) cable from the battery before installing this accessory.
- After turning the ignition switch OFF, wait more than 10 seconds and then remove the negative cable of the battery.
- The memories of the trumpeter and clock will be erased when you disconnect the battery. Reset the clock after reconnecting the battery.
- Reinstall the removed parts on the motorcycle and make sure that the wires and harnesses are not pinched.
-
Remove the motorcycle’s parts as shown.
-
Remove the antenna as shown.
-
Remove the motorcycle’s parts as shown.
-
Open the left saddlebag lid as shown.
-
Remove the left side cover, and disconnect the negative (-) cable from the battery.
-
Attach the connector holder according to the dimension shown.
-
Mark the junction lead headset in the position shown.
-
Cut the cushion tape to the dimension as shown.
-
Secure the junction lead harness as shown.
-
Secure the junction lead harness as shown.
-
Install the center rear top cover in the reverse order of removal.
• Confirm that any wire harness is not caught or too tight. -
Route the junction lead headset as shown.
-
Connect the junction lead headset as shown.
-
Secure the junction lead headset with the wire tie as shown.
-
Install the motorcycle’s parts in the reverse order of removal.
• Confirm that any wire harness is not caught or too tight. -
Secure the junction lead head set to the connector holder as shown.
Application
GL1800B
Publication No.
MII 14360 Issue Date
December 2012
Documents / Resources
|
HONDA GL1800B Junction Lead
Headset
[pdf] Instruction Manual
GL1800B Junction Lead Headset, GL1800B, Junction Lead Headset, Lead Headset,
Headset
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>