slime P195l65R15 Power Sport Inflator Instruction Manual

slime P195l65R15 Power Sport Inflator

Product Information

The product is an Air Adapter, designed for inflating tires and other soft inflatables. It features a dial gauge for monitoring air pressure and various adapters for different usage scenarios. The product is powered by a 12-volt DC power outlet and comes with a power cord for easy connectivity. It also has a built-in LED light for convenience.

• Tire Inflation Time: 9.1ft. (1.80 m)
• CFM (LPM): 15
• Dial Gauge: 5mm x 10mm
• Power Source: 12-volt DC power outlet
• Power Cord Length: 7.5in. (19cm)
• Replaceable Fuse: 15A 250V
• Air Hose Length: 9.8ft. (3.0m)
• Total Reach: 7 Lumens

Product Usage Instructions

Inflating Tires:

1. Turn off the inflator.
2. Refer to your vehicle owner’s manual or the driver’s side door jamb to determine the correct tire pressure.
3. Connect the inflator to the tire valve securely.
4. Plug the inflator power cord into the female 12V plug receptacle.
5. Follow the instructions below based on your adapter type:

Using Direct Pre-wire Adapter (motorcycles):

1. Attach the cables to the battery, starting with the positive (red) side.
2. Plug the inflator power cord into the female 12V plug receptacle.
3. Follow the instructions for inflating tires.

Using Direct Connect Adapter (ATV/Mowers):

1. Attach the battery clips to the battery, starting with the positive (red) side.
2. Plug the inflator power cord into the female 12V plug receptacle.
3. Follow the instructions for inflating tires.

Troubleshooting:
If you experience any issues with the inflator, follow these troubleshooting steps:

The inflator does not turn on:

1. Check the power plug and ensure it is firmly inserted into the receptacle. Twist it back and forth to ensure a secure connection.
2. Inspect the receptacle and plug terminals for dirt or debris. Use a non-conductive probe to clean them.
3. Check the vehicle power outlet fuse. It should be at least 15 amps.
4. If necessary, replace the fuse located in the plug adaptor with a 15A 250V 5mm x 20mm fuse.

Inflator runs but does not inflate:

1. Ensure that the connector is fully secured on the tire valve.
2. Check the tire for leaks and inspect the hose for breaks, leaks at fittings, and damage to the valve core.

Inflator runs slowly:

1. The inflator may have overheated from excessive use. Turn it off and allow it to cool for 30 minutes.
2. Check the condition of your vehicle’s battery. Low voltage can affect the inflator’s performance.

Note : If the tire is completely deflated, it may be necessary to jack up the tire before inflating to prevent air leakage due to separation from the rim. Dispose of this product at an e-waste recycling collection point or facility. Do not place it in the trash or standard recycling receptacle. For warranty details, the manufacturer guarantees that the product will meet specifications for one year from the date of purchase when used as directed. The manufacturer’s liability and customer’s remedy under any warranty claim are limited to a manufacturer’s coupon upon return of proof of purchase.

FEATURES

ATTENTION: READ ALL INSTRUCTIONS CAREFULLY FAILURE TO FOLLOW WARNING INSTRUCTIONS CAN RESULT IN FIRE, PERSONAL INJURY OR PROPERTY DAMAGE

CAUTION: DO NOT OVER-INFLATE HOT DO NOT HOLD IN HAND WHILE OPERATING PLACE IN FLAT OR O sNA HARD, CLEAN SURFACE

1. DO NOT run the vehicle while the inflator is operating. You may need to be in an “accessory” or “on” position. Please make sure the emergency brake is set and the car is in the park. Keep the inflator out of reach of children.
2. DO NOT use the inflator continuously for more than 12 minutes. Allow the unit to cool for approximately 30 minutes between uses. Do not leave the inflator unattended.
3. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful not to inflate items beyond their capacity.
4. While operating, never block the inflator input or output.
5. For use with 12-volt DC power outlets rated 15 amps or higher. Do not use older 8-amp cigarette lighter receptacles.

TECH SPECS

• TIRE INFLATION TIME 11 min
• CFM(LPM} 0.39 (11.0 LPM}”
• DIALCAUGE 0-700 PSI I {0-78AR}
• POWER SOURCE 11-volt accessory power outlet
• POWER CORD LENGTH 9.1 ft. (1.80 m}
• REPLACEABLE FUSE 15A 150V 5mm x 10mm
• AIR HOSE LENGTH 7.5 in. {19cm}
• TOTAL REACH 9.815 ft. (3.0m}
• LED LIGHT 7Lumens

{0-35 PSI, Standard Tire: P19Sl65 R15} {@ 0 PSI/BAR}

INFLATET IRES

1. Securely screw the air hose valve connector onto the valve stem.
2. Plug the power cord into a 12-volt accessory power outlet.
3. Turn on the inflator. Inflate the tire to the manufacturer’s recommended air pressure.
   • Turn off the inflator.

NOTE : Correct tire pressure can be found in the vehicle owner’s manual or on the driver’s side door jamb.

USING ADAPTER CABLES

Direct Pre-wire Adapter motorcycles

1. Attach cables to the battery, positive (red) side first.
2. Plug the inflator power cord into the female 12V plug receptacle.
3. Follow instructions for Inflating Tires

Direct Connect Adapter ATV/Mowers

1. Attach battery clips to battery, positive (red) side first.
2. Plug the inflator power cord into the female 12V plug receptacle.
3. Follow instructions for Inflating Tires.

TROUBLESHOOTING

The inflator does not turn on:

1. Check the power plug and push it firmly into the receptacle, twisting it back and forth.
2. Check receptacle and plug terminals for dirt, or debris. (Use a non-conductive probe, not fingers or metal).
3. Check the vehicle power outlet fuse. It should be 15 amps minimum.
4. Check the fuse. It may have blown: The 12V fuse is located ——-~–1 in the plug adaptor: unscrew the tip, remove the fuse, and inspect. If necessary, replace the fuse with 15A 250V 5mm x 20mm.

lnflator runs but does not inflate:

1. Be sure the connector is fully secured on the tire valve.
2. Check the tire for leaks, check the hose for breaks and leaks at fittings, and check the valve core for damage.

lnflator runs slowly:

1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for 30 minutes.
2. The voltage may be too low. Check the condition of your vehicle’s battery.

NOTE: lf the tire is deflated, it is possible that the tire could separate from the rim allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary to jack up the tire before inflation.

• Dispose of this product at an e-waste recycling collection point or facility.
• Do not place it in the trash or standard recycling receptacle.

WARRANTY :
For one year from the date of purchase, the manufacturer guarantees that this Product will meet the specifications when used as directed. The manufacturer’s sole liability and Customer’s sole remedy under any warranty claim is limited to the Manufacturer’s coupon upon return of proof of purchase.

QUESTIONS OR COMMENTS:
Call (888)457·5463 or visit www.slime.com ITW Global are Repair• 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA Slime® is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.

References

• No more flat tires! – Slime Products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>