American DJ PAR-56 Multi Color Lamp And Gel Replacement User Guide
- June 13, 2024
- American DJ
Table of Contents
- American DJ PAR-56 Multi Color Lamp And Gel Replacement User Guide
- Par-46, 56, and 64
- LAMP AND GEL REPLACEMENT
- WARNING! The Par can lamp is packed to protect against cracking during
- WARNING! The Par can lamp is packed to pro- tect against cracking during
- Color Gel Replacemet
- Lamp Replacement cont.:
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
American DJ PAR-56 Multi Color Lamp And Gel Replacement User Guide
Par-46, 56, and 64
LAMP AND GEL REPLACEMENT
This Par can has been tested and the lamp has been installed at the factory. However, the lamp is not connected to the socket. You must remove the packing foam and connect the lamp to the sock- et. There is no power switch, after plugging the Par can in, it will light up. This Par can is fitted with a lamp which is highly susceptible to damage if improperly handled. Never move the fixture until the lamps have had ample time to cool. Remember, lamps are not covered under warranty conditions.
WARNING! The Par can lamp is packed to protect against cracking during
shipping. Please remember to remove all packing material before connecting to a power source.
Lamp Replacement: Caution! Always disconnect the main power before attempting to replace the lamp. Remember always replace with the same type lamp.
WARNING! The Par can lamp is packed to pro- tect against cracking during
shipping. Please remember to remove all packing material and connect the lamp to the socket before connect- ing the Par can to a power source.
Color Gel Replacemet
-
Press down on the gel release clip.
-
While pressing down on the gel releae clip, simply slide the color gel out.
-
Disconnect the main power, and allow ample time for the lamp to cool.
-
Pull the thumb knob located on the top of
-
. Slide the back end apart from the front
Lamp Replacement cont.:
-
. Disconnect the lamp from the socket.
-
Squeeze the lamp retainer ring together and remove it and “free” the lamp.
-
Slide the old lamp out.
-
Slide the new lamp in.
-
Reconnect the lamp to the socket..
-
Replace the lamp retainer ring to secure the lamp in place.
-
Reconnect the back end to the front half.
©American DJ® A Division of the American DJ Group of Companies
American DJ® World Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA
Tel: 323-582-2650 / Fax:
323-582-2610
Web: www.americandj.com / E-mail:
info@americandj.com
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>