DSE9476 24 V 20 A Battery Charger Instruction Manual
- June 13, 2024
- DSE
Table of Contents
DEEP SEA ELECTRONICS
DSE9476: 24 V, 20 A Battery Charger
Installation Instructions
DANGER OF DEATH: LIVE PARTS exist within the DSE9476 enclosure. The enclosure cover must not be removed.
INSTALLATION
The DSE9476 is a 24 V, 20 A battery charger which is designed to be mounted within a control panel, utilising the integral mounting holes. The DSE9476 battery charger is fit-and-forget. It may be permanently connected to the A.C. supply and the load, with no requirement to disable the charger during times of heavy load (such as engine cranking) or when in parallel with a charging alternator.
BATTERY SUITABILITY
The charger is factory set by DSE to suit Lead Acid batteries, configuration
is possible to suit other battery types using the DSE Configuraiton Suite PC
Software which is available from
www.deepseaplc.com.
Care must be taken to ensure the batteries connected to the charger are of the
correct ‘technology’ to suit the setting of the charger.
INDICATIONS
The DSE9476 Battery Charger features LED indicators to show the battery
charger status.
DIMENSIONS AND MOUNTING
| Parameter | Specification |
|---|---|
| Case Dimensions | 248 mm x 183 mm x 76 mm (9.74 ” x 7.19 ” x 3.00 ”) |
| Mounting Holes Dimensions | Suitable for M5 (0.23 ” diameter) |
| Mounting Hole Spacings | 233 mm x 150 mm (9.17 ” x 5.91 ”) |
NOTE: The DSE9476 battery charger is designed to be mounted with the base
to a vertical surface with the terminal strips at the bottom.
NOTE: This document is intended as a ‘quick start’ guide only. For full
operating instructions and specifications, refer to DSE publication: 057-282
DSE9476 Operator Manual.
TYPICAL CONNECTION DIAGRAM
NOTE 1
A 120 OHM TERMINATION RESISTOR MUST BE FITTED IF IT IS THE FIRST OR LAST
DEVICE ON AN RS485 LINK
NOTE 2
FUSE APPROPRIATELY AND AS CLOSE TO THE BATTERY AS POSSIBLE TO PROTECT THE
CABLES AND BATTERY
NOTE 3
FUSE APPROPRIATELY AND AS CLOSE TO THE BATTERY CHARGER AS POSSIBLE TO
PROTECT THE CABLES AND BATTERY
| Parameter | Specification |
|---|---|
| Connection Type | Screw terminal, rising clamp, no internal spring |
| Min Cable Size (AC Supply) | 2.0 mm² (AWG 15) |
| Min Cable Size (Charge Output) | 1.0 mm² (AWG 18) |
| Min Cable Size (All Other Connections) | 0.5 mm² (AWG 20) |
| Max Cable Size (AC Supply) | 3.3 mm² (AWG 12) |
| Max Cable Size (All Other Connections) | 2.5 mm² (AWG 14) |
| Recommended AC Fuse | 230 V AC Input |
| 5.0 A anti-surge | 110 V AC Input |
10.0 A anti-surge
Deep Sea Electronics Plc.
Tel: +44 (0)1723 890099
Fax: +44 (0)1723 893303
Email:sales@deepseaplc.com
Web:www.deepseaplc.com
Deep Sea Electronics Inc.
Phone: +1815-316-8706
Fax: +1 (815) 316- 8708
Email:sales@deepseausa.com
Web:www.deepseausa.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>