DENVER ACT-320 Action Camera with 2 Inch Screen Instruction Manual
- June 13, 2024
- Denver
Table of Contents
DENVER ACT-320 Action Camera with 2 Inch Screen
Introduction to appearance and keys
Start using
-
Charge the built-in lithium battery
Connect the camera to the computer for charging, at this time, the charging indicator will be in blue, and it will be off after charging. Generally, it takes 2-4 hours to charge the battery. -
Use the storage card
-
Push the Micro SD card into the slot till it is in place as per the instruction in concavely engraved words by the storage card slot.
-
To take out the Micro SD card, press the tail of the storage card inwardly softly and it will be popped out.
Please notice: Some UHS (ultra high-speed) cards do not work, as they are not 100% backward compatible
Note: There’s no built-in memory unit in the camera, so make sure to insert a storage card into it prior to use it is recommended that a Micro SD card of better quality be used). -
Power on/off
-
Power on: Press Power key for 3 seconds, the screen will be on and the camera will be started.
-
Power off: Press Power key for 3 seconds when the camera is in the idle state to turn it off.
-
Power off when the camera is lack of electricity. When electrical quantity of the battery is very low, an icon of will be displayed on the LCD screen, prompting you to charge it in time.
-
Video recording mode
After power is on, the camera will enter video recording mode directly and in preview mode, press the Shutter key to start video recording; Press it again to stop shooting. If the memory card is full or electrical quantity is low, it will also stop shooting. -
Taking photo
After power is on, press power key to enter shooting mode, and in preview state, press shutter key to take a photo.
Technical parameters
Please notice – All products are subject to change without any notice. We
take reservations for errors and omissions in the manual.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S.
DISPOSAL
Electric and electronic equipment and included batteries contains materials,
components and substances that can be hazardous to your health and the
environment if the waste material (discarded electric and electronic equipment
and batteries) is not handled correctly. Electric and electronic equipment and
batteries is marked with the crossed-out trash can symbol, seen above. This
symbol signifies that electric and electronic equipment and batteries should
not be disposed of with other household waste, but should be disposed of
separately. As the end user it is important that you submit your used
batteries to the appropriate and designated facility. In this manner, you make
sure that the batteries are recycled in accordance with the legislature and
will not harm the environment.
All cities have established collection points, where electric and electronic
equipment and batteries can either be submitted free of charge at recycling
stations and other collection sites, or be collected from households.
Additional information is available at the technical department of your city.
Hereby, Inter Sales A/S declares that the radio equipment type ACT-320 is in
compliance with Directive 2014/53/EU. The full text of the EU Declaration of
Conformity is available at the following internet address: www.denver-
electronics.com and then click the search
ICON on the topline of website. Write model number: ACT-320. Now enter the
product page, and red directive is found under downloads/other downloads.
Operating Frequency Range: 50-60Hz
Max Output Power: 4.2V 350mAh
DENVER ELECTRONICS A/S
Omega 5A, Soften
DK-8382 Hinnerup
Denmark
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>