SWANDOO CHARLIE i-Size Booster Seat Instruction Manual

: June 13, 2024
: SWANDOO

Table of Contents

SWANDOO CHARLIE i-Size Booster Seat
Product Information
Product Usage Instructions
PRODUCT PARTS
INSTALLING IN THE VEHICLE
WASHING AND CARE
PRODUCT LIFETIME WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SWANDOO CHARLIE i-Size Booster Seat

Product Information

The i-Size Booster Seat is designed for children from 100 to 150 cm (approximately 3.5 to 12 years) in a forward-facing direction. It is certified to meet the demanding safety regulations of i-Size, ECE R129/03. The seat is equipped with intuitive seat belt routing for secure installation every time.
The product includes various parts such as an adjustable headrest, headrest strap adjuster, shoulder belt guide, lap belt guide, ISOFIX sliding trigger, ISOFIX connector, ISOFIX release puller, ISOFIX safety indicator, ISOFIX guides, sun cap fastener (sold separately), fabric covers, fabric cover installation tool, user manual pocket, side impact buddy, and side impact buddy socket.
Please note that the compatibility of this seat with your vehicle may be reduced when used for stature heights above 135 cm. It is important to refer to your vehicle manufacturer’s user manual to ensure i-Size seating position compatibility.
For the latest version of the user manual and to check the compatibility of the seat with your vehicle, please visit swandoo.com/charlie-user- manual and scan the QR code or visit swandoo.com/charlie compatibility.

Product Usage Instructions

Before using the i-Size Booster Seat, read your vehicle owner’s manual to familiarize yourself with child safety seat instructions and locate the ISOFIX anchorage points.
Ensure that your vehicle seat has automatic three-point belts approved in accordance with UN Regulation No. 16 or a comparable standard.
Do not use the seat with a two-point belt.
Install the seat in the vehicle by following the instructions provided in the user manual.
Place the Side Impact Buddy in the appropriate socket for enhanced safety.
Secure your child in the seat by using the adjustable headrest, headrest strap adjuster, shoulder belt guide, and lap belt guide.
When removing the seat from the vehicle, follow the instructions provided in the user manual.
If necessary, remove the fabric covers for washing by using the fabric cover installation tool.
Refer to the important information section in the user manual for additional guidelines and safety precautions.
The i-Size Booster Seat comes with a product lifetime warranty for your peace of mind.

This is the perfect time to grab a tea or coffee before digging into some important information.
Go on! We’ll be waiting for you! 🙂

Please note: We give our best creating this content in multiple languages. We ask for your under-standing in case of translation errors; please get in touch with us with improvement ideas, or if you spot any mistakes. Thank you!
For maximum protection and comfort of your child, it is essential that you read the entire man-ual carefully and follow all instructions on how to install and use this product. Incorrect operation may result in serious injuries or even death.

NOTICE
This product has been approved according to the strictest European safety standards (ECE R129/03) and is suitable for children from 100 to 150 cm (from approximately 3 to 12 years) in forward facing direction.
It can only be used for vehicle seats with automatic three-point belts approved in accordance with UN Regulation No. 16 or a comparable standard.
Charlie is classified as “i-Size booster seat” for children from 100 to 150 cm stature height and fits “i-Size seating positions” as indicated by the vehicle manufactures in the vehicles’ user manual. When used for stature heights above 135 cm the compatibility of this seat with your vehicle might be reduced.
Please find the latest version of this user manual online at swandoo.com /charlie-user-manual. The latest digital version may contain important updates and overrules previous versions.
In case of discrepancy, the latest update should be followed.

Please scan the QR code or visit swandoo.com/charlie- compatibility to check the compatibility with your vehicle.

PRODUCT PARTS

A Adjustable Headrest
B Headrest Strap Adjuster
C Shoulder Belt Guide
D Lap Belt Guide
E ISOFIX Sliding Trigger
F ISOFIX Connector
G ISOFIX Release Puller
H ISOFIX Safety Indicator
I ISOFIX Guides
J Sun Cap Fastener (Sold Separately)
K Fabric Cover
L Fabric Cover Installation Tool
M User Manual Pocket
N User Manual
O Side Impact Buddy
P Side Impact Buddy Socket

BEFORE YOU GO-GO
Please read your vehicle owner’s manual for instructions related to child safety seats, and to locate the ISOFIX anchorage points. This seat can be used both with the ISOFIX connectors latched, or unlatched and stowed.

The seat must not be used with a two-point belt.
The child seat may not be used on car seats facing to the side of the direction of travel.
Use of the child seat is permitted on rear-facing seats e.g. in a van or minibus, provided that the seat is permitted for transport-ing an adult. Please note that the vehicle headrest must not be removed when fitting on a rear-facing seat! Even if not in use, the child seat must always be secured with the safety belt.
The safest place to install this product is in the rear seats of your vehicle.
If you need to install this child seat in the front passenger seat, and your car is equipped with airbags, push the passenger seat as far back as possible. However, make sure the shoulder belt guide of this seat is always in a forward position compared to the B Pillar of the vehicle.

INSTALLING IN THE VEHICLE

INSTALLATION WITH ISOFIX

If needed, place the two ISOFIX guides ( I ) on both ISOFIX anchor points between the seat and the backrest.
Extend the ISOFIX connectors ( F ) by pulling the ISOFIX release puller D ( E ) in the front of the seat. The ISOFIX connectors will slide to their outermost position. $SWANDOO-CHARLIE-i-Size-Booster-Seat $6$$
Position the child seat on the seat in the car and insert both connectors into the ISOFIX anchor points until you hear a “click”.
Check that the ISOFIX safety indicators ( H ) have turned green.
Pull the release pulleDr ( E ) again and…
FOR INSTALLATION WITHOUT ISOFIX, START HERE!
push the bottom part of the child seat against the vehicle seat until it is firmly positioned and tight to the seat. If the headrest of the vehicle seat is interfering with the child seat, adjust the headrest or remove it completely (do not remove the headrest in rear facing vehicle seats). The entire back surface of the Charlie seat must be in contact with the backrest of the vehicle’s seat.
Pull the three-point belt out and feed the upper part of the belt through the shoulder belt guide ( C ) over the green belt path indicator. Ensure the belt guide is closed again and that the belt is not twisted. SIDE IMPACT BUDDY
Charlie offers high-level integrated side impact protection. The Side Impact Buddy improves the protection even further.
Insert the Side Impact Buddy ( O ) into the red oval socket ( P ) on the side of the seat.
Rotate the Side Impact Buddy 90 degrees until it snaps in. The Side Impact Buddy always has to be placed on the window side of the child seat and it may not fit or be compatible with every vehicle.
SECURING YOUR CHILD
Pull the headrest strap adjuster ( B ) and adjust the headrest position whilst your child is sitting in the child seat.
Move the headrest ( A ) then slide it upward or downward. Adjust the headrest until the eye indicator matches the eye level of your child or you cannot put about two fingers (approximately 2 cm) between the shoulder of your child and the lower edge of the headrest.
Pull out the three-point belt, position it in front of the child and lock the belt tongue into the buckle of the vehicle.
Grab the diagonal belt and pull towards the retractor to remove slack from the lap belt.
- For best protection make sure the belt sits tight and is not twisted. Make sure the lap belt is placed as low as possible on your child’s pelvis and not sitting on the abdomen of your child.
- The diagonal part of the belt should sit on your child’s collarbone in the centre of the shoulder area and not touch the neck. Adjust the headrest for a better position if necessary.
- Always check the correct installation and restraining of your child before you start driving.
- Do not leave your child unattended in the child seat, not even for a short time.
- Cover the product when exposed to direct sunlight. Parts of the seat may get too hot for your child’s skin. Check the temperature before placing your child into the seat.
- Do not use this child seat outside of a vehicle. $SWANDOO-CHARLIE-i-Size-Booster-Seat $19$$
- Show your child how the belt has to be placed and how to tighten the belt by themselves.
- “…The purpose of training is to tighten up the slack, toughen the body, and polish the spirit.” Sensei
- REMOVING FROM THE VEHICLE
Push the locking mechanism of the shoulder belt guide inwards and slide the three-point belt out of the belt guide.
Open the ISOFIX connectors ( F ) by pulling on the ISOFIX release puller ( G ) right on the side of the connectors.
- In case the ISOFIX release strap is not accessible use the front puller ( E ) to move the seat forward.
Push the ISOFIX connectors back into the seat while pulling on the strap on the front ( E ) and then remove the seat from the vehicle.

WASHING AND CARE

REMOVING THE FABRIC COVER FOR WASHING
Remove the fabric from the headrest by simply lifting it up from the edges. Open the fabrics on the back of the child seat. To prevent the cover from slipping forwards whilst in use, there are two small hooks beneath the cover behind the seating position, holding it in place.
Ensure the cover is detached from these hooks by pinching the cover at each side of the seating area and pulling towards the centre of the seat prior to removing the fabric completely. Loosen the whole cover by lifting it up from the edges.

REPOSITIONING OF THE FABRIC COVER
Find the fabric installation tool behind the head-rest. Tuck the fabric edge into the right position. Unless already removed for washing, you’ll find

the fabric installation tool behind the headrest. Ensure the fabric cover is reinstalled as it was before removal. You can follow the previous steps in reverse order to make sure everything is in place.

WASHING INSTRUCTIONS

$SWANDOO-CHARLIE-i-Size-Booster-Seat $22$$

Please wash before first use!

Machine washable: Fine/delicate programme. Hand wash recommended.
Use mild detergents. Do not dry clean, bleach or tumble dry. Keep away from your dog, your cat and direct heat. Do not use bleach, abrasive, upholstery or aggressive cleaning agents.
Clean the plastic parts and the integrated harness system with a mild detergent and warm water. Do not use lubricants.
Washing this fabric cover will not wash away your sins.

Wrinkles?
Remove any wrinkles from the fabric cover with a steamer. If you don’t have one available, try the steam function of your iron instead.
While steaming, be sure not to touch any plastic parts of the seat with the iron. Please be careful with hot steam! Keep it far from your body, your cat, your dog, mother-in-law, house plants… etc. You get the point 🙂

The fabric cover is a safety feature and the child seat should never be used without it.
If the cover needs replacing at any time, only use official Swandoo Charlie fabrics.

IMPORTNAT INFORMATION

Never use the product in any configuration or assembly method not shown in the instructions.
Do not use any load bearing contact points other than those described in the instructions and marked on the child restraint.
Make sure luggage or other objects are properly secured. Unsecured luggage may cause severe injuries to children and adults in an accident.
Only adults should fix or adjust the product. Do not make any changes to the product. This could affect its performance and make it unsafe.
Do not use the product with damaged or missing parts.
Do not use a second-hand child seat or child seat whose history you do not know. It is dangerous to use unauthorized or changed products!
Ensure all rigid parts of the seat are installed correctly and can not get damaged through everyday use (eg. by getting trapped in the door of the vehicle).
Do not use the product if there is any evidence of unlicensed modification.
Do not remove any labels on the product. They contain important information.
Your Swandoo Charlie must undergo regular maintenance.
This product should be replaced when it has been subject to violent stress in an accident.

PRODUCT LIFETIME WARRANTY

Our warranty reflects our confidence in the high quality of our design, engineering, production and product performance. In case of a defect, please present your proof of purchase and the product’s serial number which is located on the bottom of the product.
The warranty covers all manufacturing and material defects existing at the date of purchase, or appearing within 2 years from the date of receipt from the retailer. This warranty does not cover damages caused by normal wear and tear, negligence, accidents, abuse, use of unauthorized accessories or a result of failing to comply with the user manual.
You can extend to a product lifetime warranty for free, simply by registering your product online within 3 months from the date of purchase. In order to do so, peel off the warranty sticker that you find on Charlie and scan the QR-Code. You can also visit: swandoo.com/register-product.
If you have any questions or concerns about this product, or this user manual, please contact us before using the product. We look forward to hearing from you!

VEHICLE COMPATIBILITY

Charlie is suitable for fixing into the seat positions of the vehicles listed below, providing approved ISOFIX points are fitted and available. This child restraint system may be compatible with other vehicles however, we have not yet tested Charlie with all vehicles.
This vehicle compatibility list refers to ISOFIX posi-tions only. In principle, use of the seat in positions without ISOFIX is always possible with stowed ISOFIX connectors.
If in doubt, consult either Swandoo or the retailer. For the latest car list please visit our website.
In some vehicles, head space in the rear seats is limited. If you fasten Charlie using the ISOFIX arms in these vehicles, it may not be possible to use the child seat up to a standing height of 1.50 m. This may be the case, for example, if the headrest hits the vehicle’s C-pillar. Please observe the heights shown in the vehicle compatibility list.
When a vehicle is marked with *, the space for the head might be limited to 1.35 m standing height for specific models of this vehicle. Recent model updates may not listed as model updates are only mentioned when seating positions
are changed.

ALWAYS WITH YOU