Camden CM-47S Round Mounting Box Instruction Manual
- June 13, 2024
- Camden
Table of Contents
CM-69S & CM-47S
Installation Instructions
Battery and transmitter not included.
Must be ordered separately.
CM-47S Round Mounting Box
Parts Included:
9V battery mounting clip (CM-69 only)
4 X 6-32 self-tapping screws
4 solid wall anchors
File: CM-69S & CM-47S
Revised: March 17, 2009
Part No: 40-82B058
Installation Instructions
-
Locate the 4 pilot holes in the enclosure. They are not drilled all the way through so that you may drill your own holes to match an existing layout or the site conditions
-
Drill 4 X 5/32” (minimum) holes through the base.
-
Mark the drilling locations on the wall with a pencil or center-punch.
-
Remove the base assembly and drill holes in the wall.
Insert the appropriate wall fasteners. -
Fasten the base assembly to the wall with the supplied screws
-
a. If using radio controls, insert the 9V mounting clip (CM-69 only) for the battery and use the double sided tape or velcro to secure the transmitter.
b. If hard-wiring, use one of the supplied knock-outs to bring the wiring into the box. -
Hand insert and turn the two 6-32 screws supplied with the switch. Install wiring connectors to the switch, center, and place the switch over the two screws.
-
Tighten the screws firmly using the Allen key provided with switch.
IMPORTANT! As you tighten the screws, ensure the switch stays centres in the opening and does not rub on the inside edge of the housing.
5502 Timberlea Blvd.
Mississauga, Ontario L4W 2T7
905-366-3377 Toll Free:
877-226-3369
www.camdencontrols.co
Documents / Resources
|
Camden CM-47S Round Mounting
Box
[pdf] Instruction Manual
CM-47S Round Mounting Box, CM-47S, Round Mounting Box, Mounting Box
---|---
References
- Camden Door Controls is the industry leading manufacturer of door activation and locking products.
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>