Vipcase C200 Instruction Manual
- June 13, 2024
- Vipcase
Table of Contents
C200 finger ring magnetic
suction charging bank
Please read the following before
using this product:
How to place the magnetic charger:
Keep your phone centered on the wireless charging pad when charging
wirelessly. lathe phone does not begin charging right away, adjust the
position until its charging icon appears. Refer to the figure below for
proper device placement. 
Charge & Discharge Instructions:
When discharging,
the indicator displays the battery level as follows:
| Battery Level | LEDl | LED2 | LED | LED4 |
|---|---|---|---|---|
| 0-25% | On | Off | Off | Off |
| 25-50% | On | On | Off | Off |
| 50-75% | On | On | On | Off |
| 75-100% | On | On | On | On |
| Under voltage | Off | Off | Off | Off |
Low-current discharge:
Press and hold the button to enter low current mode for 5 hours. This mode can
be used to charge small devices such as Bluetooth headsets. Long press again
to exit low current mode.
When charging, the indicator displays the battery level as follows:
| Battery Level | Led 1 | LED2 | LED3 | LED4 |
|---|---|---|---|---|
| 0-25% | Blinking | Off | Off | Off |
| 25-50% | On | Blinking | Off | Off |
| 50-75% | On | On | Blinking | Off |
| 75-100% | On | On | On | Blinking |
| Fully Charged | On | On | On | Or |
| Green Light | Magnetic Charger Working Status | |||
| --- | --- | |||
| On | Working | |||
| Off | Not working |
Charge your phone:
Recharge your
Magnetic Portable Charger:
Product parameters:
| Capacity | 3.85V/S0OOMA/19.25WH |
|---|---|
| Input Port | Type-C |
| Output Port | Type-C/Wireless Charger |
| Type-C Input | 5V/3A, 9V/2A,12V/1.SA |
| Type-C Output | 5V/3A, 9V/2.2A,12V/1.67A |
| Wireless output | 5W,7.5W,10W,15W |
| Product size | 3.962.65×0.61in |
| Product weight | 4.43oz |
| Button | click to switch on, double click to switch off, long press to enter |
small current mode for 5 hours
The following basic precautions should always be observed when using this product:
- Fully charge this product before using it for the first time.
- Do not disassemble, crush, puncture or short-circuit this product or expose it to liquids, fire, stoves, heaters, and other sources of heat or temperatures above 140°F (60°C).
- When this mobile power appears to be bulging, deformed, leaking, or the capacity is significantly reduced, please stop using it immediately and dispose of it properly.
- When using the magnetic charger to wirelessly charge a device with a protective case, please make sure that the protective case is non-metallic and not more than 4 mm thick.
- When the mobile power is not used for a long time, please keep the battery level at about 25-50% and store it in a cool and dry environment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator & your body.
Here is how we can connect:
vipcasenoworry@163.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>