GEORGE KOVACS P1551-66A-L Trizay 32 in 1 Light Black LED Vanity Light with Etched White Glass Shade Instruction Manual
- June 13, 2024
- GEORGE KOVACS
Table of Contents
INSTALLATION INSTRUCTIONS
Item#P1551-66A-L P1552-66A-L P1553-66A-L (Rev. 05/09/2023)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OF FATF USEO RCIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION
-
Shut off power at the fuse box or circuit breaker box. If necessary, remove the old fixture and mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1) -
Secure mounting plate (A) to the outlet box (not included) using outlet box screws (B) (Size: #8-32N*L1”L). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2) -
Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided. After wires are connected, tuck them carefully inside the outlet box. FINISHING THE INSTALLATION (Fig. 1)
-
Place back plate (C) over mounting plate (A) and secure with screws (D).
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician without cutting of
wire and without damage to any decorative element to which the fixture is
attached. See installation steps for more details (Fig 3.)
a. Shut off the power.
b. To remove fixture body from wall, loosen screws (D) and back plate (C) from
mounting plate (A). Disconnect wire connectors and place fixture body on a
clean surface (Fig.1).
c. Remove screws (E) and the metal caps (H) from the fixture body and remove
glass (F).
d. Press the button with printed ”L” quick connector on LED module (G) with
screwdriver (not included) to disconnect the black wire and then disconnect
the white wire from the printed ”N” quick connector on LED module (G).
Carefully remove LED module (G) from the base.
e. Reverse steps a-d for installing the new LED module.
Your installation is now complete. Return power to the outlet box and test the
fixture.
Note : The illustration in figure 1 on this manual is for installation
purposes only. It may or may not be identical to the fixture purchased.
Dimmable with ELV and/or LED compatible wall dimmer switches
P1551-66A-L P1552-66A-L P1553-66A-L
Documents / Resources
|
GEORGE KOVACS P1551-66A-L Trizay 32 in 1 Light Black LED Vanity Light with
Etched White Glass
Shade
[pdf] Instruction Manual
P1551-66A-L, P1552-66A-L, P1553-66A-L, P1551-66A-L Trizay 32 in 1 Light Black
LED Vanity Light with Etched White Glass Shade, Black LED Vanity Light with
Etched White Glass Shade, Etched White Glass Shade, Glass Shade
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>