GEORGE KOVACS P5591-613-L Hail 1-Light Polished Nickel LED Globe Mini Pendant Light Instruction Manual
- June 13, 2024
- GEORGE KOVACS
Table of Contents
GEORGE KOVACS P5591-613-L Hail 1-Light Polished Nickel LED Globe Mini
Pendant Light
Product Information
The product is the P5591-613-L Ceiling Mount Fixture. It is a newly released model as of December 15, 2022.
Installation Instructions
WARNING! Before starting the installation process, it is crucial to shut off the power supply at the fuse box or circuit breaker.
Preparation
Shut off power at the fuse box or circuit breaker box.
CAUTION/ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only (use the Lutron MACL-153M compatible dimmer).
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
Figure 1:
- Set#: A-020-124D
- Mounting Plate
- Ground Screw
- Mounting Screw * 2
Figure 2:
- FIXTURE WIRES Black or Smooth
- FIXTURE WIRES White or Ribbed
- FIXTURE WIRES Green or Bare Copper (Ground)
- HOUSE WIRES Black (Hot)
- HOUSE WIRES White (Neutral)
- HOUSE WIRES Green (Ground)
Please refer to the provided figures for visual reference during the installation process.
INSTALLATION INSTRUCTIONS
For Ceiling Mount Fixture (New. 12/15/2022)
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARATION (Fig.1)
-
Shut off power at the fuse box or circuit breaker box. If necessary, remove the old fixture and mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clean area. Take care not to lose any small parts necessary for installation.
-
Secure mounting plate (A) to the junction box (not included), using screws (B) (Size: 8-32*1/2″L). The side of the mounting plate marked “GND” must face out.
-
Adjust the fixture wire length by loosening the screw with wrench (E) provided to desired length. Tighten the screw and wire using wrench (E) to secure wire.
CONNECTING THE WIRES (FIG. 2)
-
Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire green or bare copper), connect the fixtures ground wire to it.
Otherwise, connect the fixture ground wire directly to the mounting plate (A) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION (FIG. 1) -
Align canopy (C) onto mounting plate (A) and secure with screws (D).
-
Screw crystal ball (G) to fixture body (F) (Do not over tighten).
CAUTION/ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only (use the Lutron MACL-153M compatible dimmer).
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>