circa LIGHTING RL 2082 Allen Double Light Sconce Instruction Manual
- June 4, 2024
- circa LIGHTING
Table of Contents
circa LIGHTING RL 2082 Allen Double Light Sconce
ASSEMBLY INSTRUCTIONS
Allen Double Light Sconce
Item # RL 2082
NOTICE :
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
-
Carefully remove all parts from the box.
-
Remove the mounting plate (B) from the fixture body (E) by unscrewing the side screws (C).
-
Install the mounting plate (B) to the junction box and secure with the mounting screws (D).
-
Wrap the fixture ground wire to the green ground screw on the mounting plate (B) and secure, then connect to the ground wire in the junction box using the wire nut (A).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED. -
Connect the fixture white wire to the neutral wire in the junction box using the wire nut (A).
-
Connect the fixture black wire to the hot wire in the junction box using the wire nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE COMPROMISED. -
Install the fixture body (E) to the mounting plate (B) and secure with the side screws (C).
-
Insert bulbs (not included) into the sockets.
-
Thread the glass frame (H) to the top of the socket holder.
-
Thread the glass frame (G) to the bottom of the socket holder.
DO NOT OVER-TIGHTEN, OTHERWISE THE GLASS COULD BECOME DAMAGED.
Please note: Do not touch glass frame (H & G) and top cap (N & M), only hold bottom ring (K & L) during assembly. -
Installation is complete, turn on power at fuse or circuit breaker. Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>