Contixo DB1 Remote Control RC Walking Tyrannosaurus Rex Dinosaur Toy User Manual
- June 13, 2024
- CONTIXO
Table of Contents
Contixo DB1 Remote Control RC Walking Tyrannosaurus Rex Dinosaur Toy
Product Information
The RC T. Rex DB1 is a remote control dinosaur toy. Please note that the product colors may vary.
DB1 Remote Control:
The DB1 remote control is used to control the movements and actions of the RC T. Rex.
Head Control:
The head of the RC T. Rex can be controlled using the remote control.
Movement & Action:
The RC T. Rex can move and perform various actions as directed by the remote control.
DB1 RC T. Rex Setup:
To set up the RC T. Rex, follow the steps below:
- Align the interface.
- Install the tail on the dinosaur from top to bottom.
Dinosaur Battery Installation:
To install batteries in the dinosaur, follow the steps below:
- Install 3*AA batteries into the dinosaur.
- Ensure that the batteries are inserted with the corresponding polarities as labeled on the unit.
- Close the battery cover and tighten the screws using a screwdriver.
*Use 3AA Batteries ON/OFF:**
Make sure to use 3*AA batteries for powering the RC T. Rex. The ON/OFF switch controls the power supply.
Fill Up The Smoke Chamber:
Before using the DB1, it is necessary to fill up the smoke chamber with water. Follow the steps below:
- Fill the included bottle with water.
- Open the lid of the head of the RC T. Rex.
- Use the included bottle to add water to the smoke chamber.
Remote Battery Installation:
To install batteries in the remote control, follow the steps below:
- Use a screwdriver to remove the battery cover.
- Place two AA batteries into the remote control.
- Ensure that the batteries are inserted with the corresponding polarities as labeled on the unit.
- Replace the battery cover and screw it back into place.
Battery Warnings:
Ensure that you follow proper battery installation procedures and observe the correct polarity. Always use fresh batteries of the correct type. Do not mix old and new batteries or different types of batteries. Remove batteries from the product if it will not be used for an extended period of time. Dispose of used batteries according to local regulations.
PLEASE READ THIS MANUAL BEFORE USING. PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE
DB1 Remote Control
DB1 RC T. Rex Setup
Tail Installation
After aligning the interface, install the tail on the dinosaur from top to
bottom
Dinosaur Battery Installation
Install 3*AA batteries into the dinosaur with the corresponding polarities as
labeled on the unit. Then close the battery cover and tighten the screws with
a screwdriver.
Fill Up The Smoke Chamber
Before using DB1, fill the smoke chamber with water using the included bottle. Fill the included bottle with water. Then open the lid of the head, use the included bottle to add water
CONTACT INFORMATION
E-Mail: support@contixo.com
Website : www.contixo.com
©2021 Contixo Inc. All rights reserved. Contixo®, the Contixo logo and
associated characters, trademarks and design elements are owned and licensed
by Contixo Company
Remote Battery Installation
- Use a screwdriver to remove the battery cover.
- Place two AA’s with the corresponding polarities as labeled on the unit.
- Replace the battery cover and screw back into place.
Battery Warnings
- Insert batteries with correct polarity.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- Rechargeable batteries are to be removed from the drone before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Exhausted batteries are to be removed from the drone.
- The supply terminals are not to be short-circuited.
- In order to avoid battery leakage causing damage to the remote controler, please take out the battery if not in use for a long time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>