CONTIXO SC1 Speed Crawler User Manual
- June 9, 2024
- CONTIXO
Table of Contents
CONTIXO SC1 Speed Crawler
Powering it On
How to turn on the SC1
SC1 Wrist Remote
How to use
Put it on
Put your thumb through the rubber loop and strap it around your palm. Attach
the mode-switch button around your index finger so that your thumb can press
it easily.
Boot
Long Press Power Button to turn on.
3 LED’s blinking 3 times fast indicate the remote is booted
Remote is looking for SC1
Remote is connected, and in Mode 1
Mode 1: Default mode when device is turned
Mode 2: Alternate Controls
Mode 3: Music Player
- Click once to switch to Mode 2
- Double click to switch to Mode 3
Toggle between Stealth Formation and Truck Formation in Mode 1 and Mode 2
SC1 Remote Control
How to use
Before switching to a new remote control, you need to turn off the previously connected remote control.
Battery Installation
SC1 Battery Installation
- Use a small phillips head screwdriver to remove the battery cover.
- Attach the battery to the caonnector.
- Replace the battery cover and screw back into place.
*When removing the battery to charge, take care to unclasp the connector before pulling it off.
Remote Battery Installation
- Use a small phillips head screwdriver to remove the battery cover.
- Place two AAs with the corresponding polarities as labeled on the unit.
- Replace the battery cover and screw back into place
The battery of the remote control watch does not need to be installed. Connect the charging cable to the charging port for charging.The battery of the remote control watch does not need to be installed. Connect the charging cable to the charging port for charging.
Fill Up The Smoke Chamber
Open the stopper at the front of the car and pour water with the bottle included in the package.
Battery Warnings
- There is a certain risk of using lithium batteries, which may cause signiticant damage to people and property. Ihe end user must use it caretully and bear all the related responsibilities
- If the battery leaks, avoid contact with skin and eyes. It contact with skin occurs, wash with soap and water immediately. It contact with eyes occurs, rinse immediately with cold water tor at least 15 minutes, and seek medical attention.
- If the charger begins to emit a suspicious odor, noise, or smoke, unplug the power supply immediately.
Battery Charging
- The light turns on when charging and turns off when it is tully charged.
- Use only the original factory cable. Do not use damaged or cable of other brands.
- Do not charge expanded, leaked, or damaged batteries.
- Do not overcharge the battery. When the battery is fully charged, unplug the device.
- Do not charge near intlammable materials (eg. carpets, wood tlooring, solid wood furniture, etc.).
- Do not charge the battery immediately ater it has become hot.
- The charging temperature of the battery should be between 0-40°C (32-104°F).
- Recommend using a 5V 1A charger (Not included) tor charging
Recycling
This equipment consists of electronic components or batteries. For electronic waste, please dispose of according to local waste disposal laws and ordinances.
Charging Time
New Battery needs to be fully charged tor 180 minutes and use time is up to 20
minutes.
CONTACT INFORMATION
E-Mail: support@contixo.com
Website: www.contixo.com
©2021 Contixo Inc. All rights reserved. Contixo®, the Contixo logo and
associated characters, trademarks and design elements are owned and licensed
by Contixo Company.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>