CONTIXO SC2 All Terrain Combat Commando Military Attack Vehicle User Manual

June 13, 2024
CONTIXO

CONTIXO SC2 All Terrain Combat Commando Military Attack Vehicle

CONTIXO SC2 All Terrain Combat Commando Military Attack
Vehicle

What’s Included

  • Battle Brain
    What’s Included

  • Bullet Launcher

  • Target Assist

  • Controller

  • Wheels (2)
    What’s Included

  • Foam Bullets (36)
    What’s Included

  • Decal Sheet
    What’s Included

Battery Installation

Combat Commando Battery Installation

  1. Use a screwdriver to unscrew the battery cover and open it.
  2. Attach the battery to the connector.
  3. Screw the cover back onto the body.

Transmitter Battery Installation

  1. Use a screwdriver to open the battery cover.
  2. Place 4X 1.5V AA Batteries (Not included) with the corresponding polarities as labeled on the unit.
  3. Close the battery cover and tighten the screw.

Pairing and Connecting the Remote

  1. Flip the ON/OFF switch on the Battle Brain to the ON position
  2. Turn on the remote by pressing the Power Button on the bottom center of the remote.
    Pairing and Connecting the Remote

Battle Brain and Remote Control Frequency Matching

In the matching process, the indicator on the remote will flash repeatedly. The entire process takes 2-3 seconds and the indicator light turns off once the matching process is complete.
You can mix up to 20 Combat Commandos in the same area, however signal interference may occur.

If the Battle Brain isn’t responding to your remote, please turn off both and try again.

2 or more Battle Brains can be paired to one remote. Simply Follow the steps above to pair your remote with as many Battle Brains as you have.

Load the Bullets

Load the Bullets

Load the Bullets with the rounded tip facing out.

Installation the Cartridge

  1. Remove the bullet cartridge by pulling it towards the rear of the launcher, tilting the front of the cartridge upward, and then lifting it out.
  2. Insert the cartridge back into the bullet launcher by pushing the back of the cartridge into the small wheel at the rear of the launcher and then tilting the front of the cartridge downward until it clicks into place.
    Installation the Cartridge

Bullet Launcher Installation

Pair your bullet launcher to the Battle The bullet slot must be connected to the pusher so that the pusher can push the bullet out Brain by plugging it into the top of the Battle Brain via the Brainwave Connector and make sure the connection is in place.

Bullet Launcher Installation

Aim Assist Installation

Aim Assist Installation

  1. Open the lid of the battery cover and take out the insulating sheet to power up the 3 included L1131 button batteries. Close the cover.
  2. Slide the Aim Assist into the notch above the expulsion chamber of the bullet launcher.

Assembling and Disassembling the Wheels

Assembling and Disassembling the Wheels
Assembling the Wheels

Insert the Battle Brain into the socket of the wheel attachment. You should hear the spring loaded mechanism click into place.

Assembling and Disassembling the Wheels
Disassembling the Wheels

Pull the switches on the inside of the wheel attachment outward and pull the Battle Brain away from the attachment.

*Please make sure the connection is in place.

Troubleshooting

Symptom Cause Solution
Combat Commando won’t automatically pair with remote
  • Battery are low
  • Needs to be re paired with the remote

|

  • Charge the battery or replace the battery of remote control
  • Re-paired with the remote

Combat Commando’s green| Battery are low| Charge the battery
Robot keeps switching off| Battery are low or faulty| Charge the battery

Controls

Controls

Controls
Forward

Controls
Drift left horizontally

Controls
Rotate left

Controls
45º Drift left/forward

Controls
Backward

Controls
Drift right horizontally

Controls
Rotate right

Controls
45º Drift right (forward)

Controls
45º drift left (backward)

Controls
Raise launcher

Controls
Fire

Controls
45º Drift right (backward)

Controls
Lower launcher

Controls
Auto Demo

Gameplay

Battle Mode

It takes a lot of practice to hit targets, so start of with the larger target as this is easier to hit. The smaller target requires a more accurate shot. Battle Mode between 2 Combat Commandos can be balanced through target sizes to compensate for the skill levels of the players.

Three Lives

When the aiming point is hit, Combat Commando will make a trembling noise and one LED will turn off. The 3 lights on the head of the battle brain will blinking after it’s been hit three times, indicating the death of the Combat Commando. It will enter sleep mode after two minutes if you don’t restart Combat Commando.

Gameplay

WARNING: Not suitable for children under 3 years old due to small parts which may represent a choking hazard. Recommended for use by children over 5 years old. This product operates on 2.4GHz frequency. Do not aim at eyes or face. Do not use near crowds. Do not aim at people or animals. Laser radiation Do not stare into beam. Only use Bullets designed for this product. Do not attempt to catch the missles. Do not put your face over the bullet even if it is not being used. Do not launch any improvised object other than the one supplied or recommended by the manufacturer. Please retain this information for future reference. Adult supervision required

Battery Warnings

  1. There is a certain risk of using lithium batteries, which may cause significant damage to people and property. The end user must use it carefully and bear all the related responsibilities.
  2. If the battery leaks, avoid contact with skin and eyes. If contact with skin occurs, wash with soap and water immediately. If contact with eyes occurs, rinse immediately with cold water for at least 15 minutes, and seek medical attention.
  3. If the charger begins to emit a suspicious odor, noise, or smoke, unplug the power supply immediately.

Battery Charging

  1. The light turns on when charging and turns off when it is fully charged.
  2. Use only the original factory cable. Do not use damaged or cable of other brands.
  3. Do not charge expanded, leaked, or damaged batteries.
  4. Do not overcharge the battery. When the battery is fully charged, unplug the device.
  5. Do not charge near inflammable materials (eg. carpets, wood flooring, solid wood furniture, etc.).
  6. Do not charge the battery immediately after it has become hot.
  7. The charging temperature of the battery should be between 0-40°C (32-104°F).
  8. Recommend using a SV 1A charger (Not included) for charging.

Recycling

This equipment consists of electronic components or batteries. For electronic waste, please dispose of according to local waste disposal laws and ordinances.

Charging Time

New Battery needs to be fully charged for 180 minutes and use time is up to 30 minutes.

Customers Support

CONTACT INFORMATION
E-Mail: support@contixo.com
Website: www.contixo.com
©2021 Contixo Inc. All rights reserved. Contixo®, the Contixo logo and
associated characters, trademarks and design elements are owned and
licensed by Contixo Company.

Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals