RF INDUSTRIES RFB-1106-6 Coax Connector BNC Male Straight Crimp Nickel Body Plating Instruction Manual
- June 13, 2024
- RF Industries
Table of Contents
RF INDUSTRIES RFB-1106-6 Coax Connector BNC Male Straight Crimp Nickel
Body Plating
CABLE ASSEMBLY INSTRUCTIONS
STEP 1
STEP 2
STEP 3
STEP 4
Step 1: Cut the end of the cable evenly. Strip cable to dimensions shown in the catalog or on the outline drawing. All cuts are to be clean and square. Do not nick braid or center conductor when cutting. Slide ferrule over cable. If using strain relief or heat shrink tubing slide onto the cable first.
Step 2: Pre-tin cable conductor if using stranded cable (if needed. Slide the pin onto the center conductor until it yields against the cable dielectric. Solder pin in place.
Step 3: Slide the ferrule stud under the braid, while inserting the pin into the body. The pin will yield into place within the connector.
Step 4: Slide the ferrule over the braid until it yields against the back of the connector. Crimp the ferrule with the crimp tool as specified on the connector drawing. Trim any extra braid extending out of the ferrule end.
- 7610 Miramar Road, San Diego, CA 92126-4202
- 858-549-6340
- 800-233-1728
- Fax 858-549-6345
- E-mail: rfi@rfindustries.com.
- www.rfindustries.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>