RF INDUSTRIES RFB-1101-1SI Male Clamp Connector Instructions
- June 13, 2024
- RF Industries
Table of Contents
RF INDUSTRIES RFB-1101-1SI Male Clamp Connector
PACKAGE CONTENT
-
BODY
-
PIN
-
CLAMP
-
GASKET
-
WASHER
-
BACK NUT
ASSEMBLY INSTRUCTIONS
Step 1: Cut end of cable evenly. Strip cable to dimensions shown on
envelope/outline drawing. All cuts are to be clean and square.
Do not nick braid, dielectric or center conductor. Slide back nut, washer and
gasket onto cable. Braid must be combed for assembly of clamp.
Step 2: Place the clamp over braid and push clamp back against cable
jacket. fold back braid wire and form over the clamp evenly.
Trim extra braid If needed.
Step 3: Slide pin onto center conductor until It yields against the cable
dielectric. Pre tin cable conductor If using stranded cable (If needed}.
Solder or crimp pin In place. If soldering use minimum amount of heat.
Step 4: Properly seat groove of gasket onto clamp. Insert pin, cable and
hardware Into the body. Tighten back nut while holding body stationary.
Customer Support
RF CONNECTORS
7610 Miramar Road, San Diego, CA 92126-4202
–858-549-6340
800-233-1728 – Fax
858-549-6345 E-mail:
rfi@rfindustries.com –
www.rfindustries.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>