nordlux 2210016103 Oja 42 Inch LED Light Installation Guide
- June 13, 2024
- nordlux
Table of Contents
nordlux 2210016103 Oja 42 Inch LED Light
Product Information
- This product is a lighting fixture with a step-dimming feature. It operates on a power supply of 220-240V and 50Hz frequency. The product has an IP20 rating, indicating its level of protection against solid objects.
- The light source in this fixture is not replaceable and the entire fixture needs to be replaced after the end of its lifespan.
- Please note that before starting any work, always turn off the power supply. In some countries, electrical installation may only be done by authorized electricians. For advice, please contact the nearest authorized service center.
- The product comes with a reset function and a memorizing previous mode feature, allowing you to restore the previous settings after power loss.
- It also has three dimming levels: 100%, 50%, and 20%. The ON/OFF switch can be pressed five times to toggle between ON and OFF modes.
- For proper disposal of the product, contact your local waste management authority or the store where you purchased the product.
Product Usage Instructions
- Before starting any work, ensure that the power supply is turned off.
- Refer to the mounting instructions provided in the manual for proper installation of the fixture.
- Once installed, turn on the power supply.
- Use the ON/OFF switch to toggle between ON and OFF modes. Press it five times to switch between the two modes.
- To adjust the brightness level, use the step-dimming feature. Press the ON/OFF switch to cycle through the available levels: 100%, 50%, and 20%.
- The fixture has a reset function that allows you to restore the previous settings after a power loss. To activate the reset function, turn the fixture ON and OFF five times consecutively.
- If the light source in the fixture reaches the end of its lifespan, the entire fixture needs to be replaced.
- For proper disposal of the product, contact your local waste management authority or the store where you purchased the product.
Installation
LED FUNCTION
Specification
- IP20 The lamp should only be installed in areas where direct contact with water cannot occur.
- Class II: The lamp is double-insulated and does not need to be connected to the yellow/green earth wire.
- The lamp is only suitable for connecting directly to the mains.
- The mounting instruction must not be discarded.
- IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
- Disposal of waste equipment by users in private households in the European Union. This symbol indicates that this product must not be disposed of with your other household waste. Electrical and electronic equipment contain substances that may cause damage to human health and the environment if not recycled correctly. It is your responsibility to hand over to a designated collection point for the recycling waste electrical and electronic equipment. When handing over for correct recycling you help to prevent these products from straining nature and environment unnecessarily and to protect human health. For more information regarding correct disposal, please contact your local city office, your household waste disposal service, or the store where you purchased this product.
- For indoor use only.
Contact Information
nordlux®
- www.nordlux.com.
- Nordlux A/S Ostre Havnegade 34 DK-9000 Aalborg.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>