ProTeam TEA-107308 Super Coach Pro 6 Quart Backpack Vacuum Cleaner User Manual
- June 4, 2024
- ProTeam
Table of Contents
ProTeam TEA-107308 Super Coach Pro 6 Quart Backpack Vacuum Cleaner User Manual
GETTING STARTED
This quick start guide has basic information for the use and safe operation of this machine. However, the owner’s manual has important, detailed information. Carefully read both before starting your new ProTeam vacuum.
CARTON CONTENTS:
QUICK START INSTRUCTIONS
Unlatch the single clamp on the top of the unit and lift the cap to the vertical position.
ATTACHING WAND, TOOLS AND EXTENSION CORD:
Fasten the ends of the wands together. Pull back to open purple latch on lower half of the wand. Find the notch on the inside of lower half and the groove on the outside of the upper half – they must align. Insert the upper half into the lower by aligning the notch and groove. To tighten into position, close the purple latch when wand is at desired height. If wand does not stay at desired height, pull open the purple latch, tighten the Phillips screw as necessary, and close the purple latch again.
Twist the wand into the end of the hose.
Attach the floor tool to end of wand. Align the brass ring with the groove on the floor tool to ensure a secure fit.
Plug the extension cord into the back end of the switchbox housing (A) and twist the locking feature until it no longer tightens and you can see the yellow inner housing (B). With 12″ of slack, route the extension cord through the cord management feature on the outside of the switchbox housing to secure it (C).
Draw the top of the wand in toward your waist and twist at the waist walking backward or forward, in a side-to-side motion.
SAFE CLEANING PRACTICES:
⚠ WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY REFER TO OWNER’S MANUAL
FOR ALL SAFETY WARNINGS!
REVIEW the SAFETY LABEL on the vacuum. For additional safety information, read the vacuum owner’s manual.
DO NOT vacuum liquids or expose the vacuum to rain or water. DO NOT use the vacuum outdoors or on wet surfaces. DO NOT handle the vacuum or plug with wet hands.
DO NOT vacuum flammable or combustible materials or anything that is burning or smoking, such as cigarettes, matches or hot ashes.
DO NOT vacuum with a frayed, worn or damaged cord. Do not modify the vacuum plug. Use the extension cord provided.
ALWAYS hold the plug, not the cord, when plugging in or unplugging the vacuum.
Do not tie the extension cord to the vacuum harness or interconnecting cord, always use the cord management feature to safely hold the extension cord. Inspect all cords thoroughly before each use. Tied cords can lead to cut, frayed or worn cord. Cut, frayed or worn cords can result in electric shock, fire or injury.
Turn off the unit before unplugging. Unplug the unit from the outlet before servicing.
DO NOT pull or carry the vacuum by the cord or use the cord as a handle.
MAINTAINING YOUR VACUUM
POST THIS INFORMATION FOR REFERENCE NEAR THE LOCATION YOU STORE THE VACUUM.
WEARING THE VACUUM:
HARNESS HEIGHT ADJUSTMENT
Follow the purple numbers 1-4 for the perfect fit
USO DE LA ASPIRADORA:
Upper harness should sit between shoulder blades for most comfortable fit. The upper harness can be adjusted by sliding the upper harness along the Quick Adjust track (See side view of vacuum and harness to the left).
DO NOT adjust harness height while wearing the backpack.
To move the upper harness, pull on the purple tab located between the upper harness pad and the vacuum to release the locking feature (A). Maintain upward pressure on this pull tab and slide the upper harness identified with a purple “1”, to the desired location before releasing the tab (B).
Ensure the upper pad is locked by gently pulling on the carry handle to make
sure there is no further movement.
Loosen the shoulder straps and the waist belt. Lift the vacuum and slide your arms through the straps.
Connect the waist strap. Tighten the waist belt by grabbing the ends of the straps and pulling them toward each other and then directly outward from the center of the body. It is very important that the weight of the unit be concentrated on your hips rather than your shoulders.
Adjust the shoulder straps so that the unit fits comfortably, with the weight concentrated on your hips.
Connect the sternum strap and slide the strap up or down on the sewn-in wire support for the best fit.
FILTER MAINTENANCE:
USE ONLY GENUINE PROTEAM FILTERS TO ENSURE OPTIMAL PERFORMANCE, IMPROVED INDOOR AIR QUALITY AND MAINTAIN A VALID VACUUM WARRANTY.
INTERCEPT MICRO FILTER
EMPTY and INSPECT the Intercept Micro Filter every time you start and finish vacuuming. Replace the filter if necessary. A clogged and dirty filter restricts airflow and results in overheating and reduced suction.
To replace the Intercept Micro Filter, slide filter into Cloth Filter and secure into vacuum body.
⚠ WARNING:
To reduce the risk of fire, electric shock or injury, do not use the
vacuum with a wet cloth filter bag or dome filter. Allow the
filters to dry completely before reinstalling
CLOTH FILTER FILTRO
Once a month, or as necessary, hand or machine wash the cloth filter and let it AIR dry. DO NOT PUT IT IN THE DRYER.
DOME FILTER
Once a week, or as necessary, clean or replace the Dome Filter. First, remove the Intercept Micro Filter and Cloth Filter. Reach into the vacuum body and twist dome filter from motor.
Pull the top piece of the Dome Filter off and remove the foam media. Shake it out, rinse it, and let it AIR dry thoroughly.
(4) HEPA MEDIA EXHAUST FILTERS
To inspect or replace the HEPA media filter, press the purple release button and rotate the door away from the vacuum body (A). Grasp the plastic housing on the HEPA media filter and remove from vacuum (B). To replace the filter door, align the two tabs to the housing and press in place, then rotate the door inward (A). Be sure to press the door firmly to the vacuum as you release the purple button.
ProTeam, Inc. ph 866.888.2168 fax 800.844.4995 proteam.emerson.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>