Atlantic BFK100 Back Flash Kit User Manual
- June 5, 2024
- Atlantic
Table of Contents
Atlantic BFK100 Back Flash Kit
Product Manual
If you are installing the BFK1000 in a new construction project it is a good
idea to drill the holes and install the 2” bulkheads and male thread adaptors
before you set the FilterFalls. Drill-points have been provided below the rock
ledge on two of the back filter panels for the back-flush feed inlets. Drill the
holes using a 3” hole saw and install the bulkheads. Follow the bulkhead
installation instructions on page 9.Find the best location for the bottom
drain outlet. Drill-points are not provided for the bottom drain bulkhead
location. The bottom drain can be installed in any of the open panels on the
bottom of the FilterFalls. The center point of hole should be drilled 21/2” up
from the bottom of the FilterFalls and centered from side to side on one of
the panels. Drilling the hole 21/2” up will position the bulkhead as low as
possible. Install the bottom drain bulkhead and follow the plumbing diagram to
complete the installation. Note: Three-stage matala filter kits are available
for all FilterFalls. Matala filters will greatly increase the effectiveness of
the back-flush kit.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>