nordlux 2210606103 Oja 29 LED Light Installation Guide
- June 13, 2024
- nordlux
Table of Contents
nordlux 2210606103 Oja 29 LED Light
Mounting instruction
Removal Of Light Source
-
Lift the frame from the housing by levering the housing slightly outwards with a screw driver.
-
Remove the frame from the housing.
-
Remove the diffuser and light guide plate.
-
Unplug the light source from the housing.
Light source
IP20: The lamp should only be installed in areas where direct contact with water cannot occur.
Class II: The lamp is double-insulated and does not need to be connected to the yellow/green earth wire.
The lamp is only suitable for connecting directly to the mains.
– The mounting instruction must not be discarded
IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries electrical installation work may only be carried out by a authorized electrical contractor. (*) Contact your local electricity authority for advice.The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Disposal of waste equipment by users in private households in the European Union. This symbol indicates that this product must not be disposed of with your other household waste. Electrical and electronic equipment contain substances which may cause damage to human health and environment if not recycled correctly. It is your responsibility to hand over to a designated collection point for recycling of waste electrical and electronic equipment. When handing over for correct recycling you help to prevent these products straining nature and environment unnecessarily and to protect human health. For more information regarding correct disposal, please contact your local city office, your household waste disposal service or the store where you purchased this product.
– For indoor use only
General maintenance: Use a soft, dry cloth for dusting, and a soft, damp cloth to gently remove grease or similar stains. Never use any detergents or chemical reagents. Do not switch on the lamp before all the water has evaporated. Specifically for mouth-blown glass: Mouth-blown glass is formed manually. Because of this uniqueprocess, Hoito-ohjeet:
This product contains a light source of energy efficiency class
Customer Support
Nordlux A/S · Østre Havnegade 34 · DK-9000 Aalborg
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>