ASUS TUF Gaming LC RGB Series Liquid CPU Cooler User Guide
- June 4, 2024
- Asus
Table of Contents
TUF Gaming LC RGB Series Liquid CPU Cooler
User Guide
TUF Gaming LC RGB Series Liquid CPU Cooler
Package contents
- The Intel Mounting bracket comes pre-installed on the AIO Cooler.
- *The amount of these packaged items may vary between models.
Installing the AIO cooler
The illustrations in this section are for reference only, but the installation steps remain the same.
Prepare the motherboard and AIO Cooler. The steps may vary between Intel and
AMD motherboards.
For Intel motherboards
A. Slide the Intel backplate pins according to the CPU socket of your
motherboard.
B. Attach the Intel backplate to the bottom of the motherboard. C. Install the
standoff screws onto your motherboard. Ensure to use the correct standoff
screws for your CPU socket.
**For AMD motherboards
**
A. Push the clips on the pre-installed plastic ring securing the Intel
Mounting Bracket inwards and remove the plastic ring. B. Remove the pre-
installed Intel Mounting Bracket by lifting the bracket upwards and then
rotating it slightly. C. Attach the AMD Mounting Bracket onto the AIO cooler
by rotating the bracket slightly. D. Install the plastic ring and ensure the
clips are latched on properly to secure the AMD Mounting Bracket. Install the
fans onto the radiators, then install the fan and radiator combo to your PC
chassis.
Ensure to use the washers when installing the fan and radiator combo to your
PC chassis
Utilize as anilhas quando instalar o ventilador e o radiador no chassis do
PC.
Install the AIO cooler on the motherboard.
The steps may vary between Intel and AMD motherboards.
For Intel motherboards
Align the AIO cooler with the standoff screws installed previously, then
secure it with four (4) thumbscrew caps.
For AMD motherboards
A. Insert the AMD bracket latch into the screw hole from the bottom of the
AMD mounting bracket, then screw on a thumbscrew so that the AMD bracket latch
hangs loosely from the AMD mounting bracket.
B. Latch the AMD bracket hook onto one side of the heatsink mount.
C. Latch the AMD bracket latch onto the other heatsink mount, then tighten the
thumbscrew and ensure the AIO cooler is secured properly.
4. Connect the bundled fan cable to the fan connectors on your installed RGB
fans and your motherboard, then connect the AIO Cooler fan connector to the
AIO_PUMP, CPU_FAN, or another onboard fan header on your motherboard.
Connect the bundled RGB cable to the installed RGB fans, AIO
cooler, and RGB connector on your motherboard.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>