R V R Elettronica TX05KSS Plug Ln Transmitter Owner’s Manual

June 13, 2024
R V R ELETTRONICA

R V R Elettronica TX05KSS Plug Ln Transmitter

Product Information

The TX05KSS is a plug-in transmitter system with a power output of 5kW. It is part of the FM Stations Plug-in Series by R.V.R. Elettronica S.r.l. The transmitter is composed of PJ5KPS-CA and various combinations of accessories such as BLUES30NV, TEX30LCD/S, PTX30LCD/S, PTX30LCDDSP, and PTX30DDS. The system is designed for FM broadcasting.

Manufacturer: R.V.R. Elettronica S.r.l.

Model: TX05KSS

Ordering Information:

  • TX05KSS – 5.000W PLUG-IN system
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + 2x BLUES30NV)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + 2x TEX30LCD/S)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + 2x PTX30LCD/S)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + 2x PTX30LCDDSP)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + 2x PTX30DDS)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + BLUES30NV)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + TEX30LCD/S)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + PTX30LCD/S)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + PTX30LCDDSP)
  • TX05KSS – Plug-in transmitter, 5kW (composed of PJ5KPS-CA + PTX30DDS)

Contact Information:

Phone: +39 0516010506

Fax: +39 0516011104

Address: Via del Fonditore, 2/2c, 40138 Bologna, Italy

Product Usage Instructions

Parameters:

Parameter Unit of Measurement Value
RF Output Power kW 5.000
Frequency Range MHz N/A
Frequency Stability ppm N/A
Frequency Programmability N/A By software, with 1, 10, 100, 1000 kHz steps
Nominal Frequency Deviation N/A N/A
Maximum Frequency Deviation N/A N/A
Class of Emission N/A N/A
Modulation Mode N/A N/A
Stereo Transmissions N/A N/A
RF Output Impedance N/A N/A
RF Output Connector N/A N/A
VSWR Pre-emphasis Mode N/A N/A
Asynchronous AM S/N Ratio N/A Typically > 83 dB
Synchronous AM S/N Ratio N/A Typically N/A
Harmonics Suppression and Spurious Overall Efficiency N/A Typically N/A
RF Harmonics N/A Typically N/A
RF Spurious N/A Typically N/A
Analogue Input Level {+75 Khz (peak) deviation} N/A Typically N/A
Digital Input Level {+75 Khz (peak) deviation} N/A Typically N/A
MONO OPERATION S/N Ratio dB Typically N/A
Total Harmonic Distortion + Noise % Typically N/A
Inter Modulation Distortion SMPTE % Typically N/A
Frequency Response dB Typically N/A
Audio Input Impedance N/A Typically N/A
MPX OPERATION Composite S/N Ratio dB Typically N/A
Total Harmonic Distortion + Noise % Typically N/A
Inter Modulation Distortion % Typically N/A
Frequency Response dB Typically N/A
Audio Input Impedance N/A Typically N/A
STEREO OPERATION Stereo FM S/N Ratio dB Typically N/A
Total Harmonic Distortion + Noise (L or R) % Typically N/A
Inter Modulation Distortion SMPTE (L or R) % Typically N/A
Frequency Response (L or R) dB Typically N/A
Linear Cross Talk dB Typically N/A
Non-linear Cross Talk dB Typically N/A
Stereo Separation (Sine Wave) dB Typically N/A
Audio Input Impedance N/A Typically N/A
Digital Input Impedance N/A Typically N/A

Note: The values for the parameters are not provided in the user manual.

ORDERING INFORMATION

R V R Elettronica TX05KSS Plug Ln Transmitter-FIG1

TX05KSS
Plug-in transmitter, 5kW (composed of PJ5KPS-CA + 2x PTX30DDS).

FEATURES

  • Tunable over entire FM band (87.5 – 108 MHZ), without tuning.
  • Overall efficiency better than 70%.
  • Hot-pluggable and broadband power amplifier modules.
  • Each module features switching mode power supply to control and stabilize power supply voltage.
  • Each amplifier module provides Automatic Power Control.
  • Suitable for mono & stereo broadcast operations.
  • Protection against high VSWR, overdrive, overcurrent and overtemperature.
  • Compliance to IEC safety standards.
  • Compliance to ETSI – CCIR – FCC standards.
  • Entire transmitter can be switched off through an emergency button.
  • High redundancy guaranteed by 3 power modules of 2.2 kW RF power.
  • All measurement and working parameters are displayed on front panel.
  • Remotely controllable by telemetry system.
  • Design for 24/7 non-stop operation.
  • The transmitter include an integrated system for automatic and manual switching between two exciters.
  • In Automatic mode the changeover is activated when active power of exciter falls below 3dB.

SPECIFICATION

Parameters ** U.M. Value| Notes
---|---
GENERALS
RF Output Power| kW| 5,5|
Frequency Range| MHz| 87,5 – 108|
Frequency Stability| ppm| > 1|
Frequency programmability|  | By software, with 1, 10, 100 , 1000 kHz steps|
Nominal Frequency Deviation|  | ±75 KHz (peak)|
Maximum Frequency Deviation|  | ±150 KHz (peak)|
Class of Emission|  | 180KF8E Direct to Channel|
Modulation Mode|  | Mono, Stereo, Multiplex, SCA, RDS, Aux|
Stereo transmissions|  | Acc. to ITU-R / Rec. 450 (Pilot tone)|
RF Output Impedance|  | 50 Ω, Unbalanced|
RF Output Connector|  | 1-5/8” EIA Flange|
VSWR|  | 1.4:1 with automatic fold-back at higher VSWR|
Pre-emphasis Mode|  | 0/50 (CCIR) µs,75 (FCC) μs|
Asynchronous AM S/N Ratio|  | Typically >70dB|
Synchronous AM S/N Ratio|  | Typically > 55dB|
Harmonics suppression and Spurious|  | Typically <85db|
Overall efficiency|  | Typically > 70%|
RF Harmonics|  | Exceeds ETSI/CCIR/FCC requirements|
RF Spurious|  | Exceeds ETSI/CCIR/FCC requirements|
Analogue Input level {+75 Khz (peak) deviation }|  | -12,5 dBu – +12,5 dBu (adjustable)|
Digital Input level {+75 Khz (peak) deviation }|  | -20,0 dBFS – 0 dBFS (adjustable)|
MONO OPERATION
S/N ratio| dB| Typically > 83|
Total Harmonic Distortion + Noise| %| Typically <0,03|
Inter Modulation Distortion SMPTE| %| Typically <0,02|
Frequency Response| dB| Typically ±0,2|
Audio Input Impedance|  | 600 Ω or 10 kΩ|
MPX OPERATION
Composite S/N ratio| dB| Typically > 80|
Total Harmonic Distortion + Noise| %| Typically <0,05|
Inter Modulation Distortion| %| Typically <0,05|
Frequency Response| dB| Typically ±0,2|
Audio Input Impedance|  | 10 kΩ|
STEREO OPERATION
Stereo FM S/N Ratio| dB| Typically > 83|
Total Harmonic Distortion + Noise (L or R)| %| Typically <0,02|
Inter Modulation Distortion SMPTE (L or R)| %| Typically <0,02|
Frequency response (L or R)| dB| Typically ±0,2|
Linear Cross Talk| dB| Typically > 50|
Non-linear Cross Talk| dB| Typically > 50|
Stereo Separation (Sine Wave)| dB| Typically > 70|
Audio Input Impedance|  | 600 Ω or 10 kΩ|
Digital Input Impedance**|  | 110 Ω|

All pictures are RVR’s property and they are only indicative and not binding. The pictures can be modified without notice. These are general specifications. They show typical values and are subject to change without notice.

R.V.R. Elettronica S.r.l.
Via del Fonditore, 2/2c
40138 Bologna Italy

Phone +39 0516010506
Fax +39 0516011104
sales@rvr.it-www.rvr.it

www.rvr.it

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

R V R ELETTRONICA User Manuals

Related Manuals