Hot Tools HT7015D Turbo Ceramic Hair Dryer Instruction Manual
- June 13, 2024
- Hot Tools
Table of Contents
Hot Tools HT7015D Turbo Ceramic Hair Dryer
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of death by electric shock:
- Always “unplug it” immediately after using.
- DO NOT use while bathing.
- DO NOT place or store appliance where it can fall or be pulled into a tub or sink.
- DO NOT use near, place in or drop into water or other liquid.
- If an appliance falls into water, “unplug it” immediately. DO NOT reach into the water.
- DO NOT use an appliance with a twisted, bent or otherwise damaged cord.
WARNING: To reduce the risk of burns, fire, electrocution, or injury to persons:
- An appliance should never be left unattended when plugged in. Turn off the switch and unplug the electrical cord when not in use.
- Close supervision is necessary when this appliance is used by, on, or near children or individuals with certain disabilities.
- Use this appliance only for its intended use as described in this manual. DO NOT use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or dropped into water.
- Return the appliance to a service center for examination and repair.NOTE: Helen of Troy L.P. does not have an authorized service center.
- However if this appliance is still under warranty, return it to the Helen of Troy Consumer Service Department for replacement.
- Keep the cord away from heated surfaces. DO NOT pull, twist or wrap the cord around the barrel.
- Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
- Never use while sleeping.
- Never drop or insert any object into any opening.
- DO NOT use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- dO NOT use an extension cord with this appliance.
- DO NOT direct hot air toward eyes or other heat-sensitive areas.
- Attachments (when furnished) may be hot during use. Allow them to cool before handling.
- DO NOT place appliance on any surface while it is operating.
- While using the appliance, keep your hair away from the air inlets.
- DO NOT operate with a voltage converter.
USER MAINTENANCE INSTRUCTIONS
This appliance is equipped with a thermostat that may cycle OFF or cause the heaters to turn off if the temperature exceeds comfort level due to partially blocked air inlet or outlet openings. In the event that the appliance stops or releases only cool air during use, turn off the switches and allow the appliance to cool down, at which time the thermostat will automatically reset. During use, DO NOT block the air openings. When using this appliance near water (e.g., bathrooms), the use of an electrical outlet protected by a Ground Fault Circuit Interrupter is recommended.
Maintenance
Your appliance is virtually maintenance-free. No lubrication is needed. Keep
heated surfaces clean and free of dust, dirt, and hair spray. If cleaning
becomes necessary, unplug the appliance from the power source and wipe the
exterior with a damp cloth. If the cord becomes twisted, untwist prior to use.
WARNING : If any malfunction occurs, do not attempt to repair. This appliance has no user-serviceable parts.
STORAGE
- Unplug appliance when not in use.
- Allow appliance to cool and store out of reach of children in a safe, dry location.
- Never wrap the cord around the appliance since this will cause the cord to wear prematurely and break.
- Handle cord carefully for longer life and avoid jerking, bending sharply, twisting, or straining cord, especially at plug connections
Specification
- Dimensions 8”H x 14”W
- Scale 100%
- Material 70gsm Wood free paper
- Finishes W Fold
- Colours PMS 185C & Black
Get To Know Your Dryer
OPERATING INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to force the plug into an improper outlet. For U.S. residents only: In the event of an unusual circumstance such as immersion, the protective device will not allow the dryer to operate. Periodically check the safety plug to verify it is in proper working order. Plug the appliance in an electrical outlet and press the test button. The dryer should stop immediately. To resume operation, press the reset button.
- 1875 W dryers for US.
- This product is rated 1875W/125V/60Hz in conformance with ANS/UL STD.
- 859 Wattage in use may vary depending on the location and settings.
Styling Tips
- Gently towel-dry hair to remove excess water.
- Set dryer on highest setting and speed and circulate the airflow through your hair. Do not concentrate airflow on any one area.
- When hair is almost completely dry, lower heat and speed setting and begin to style hair as desired.
- Use the Concentrator Attachment for a more directed airflow. The Styling Pik attachment channels airflow to help straighten hair. To attach, simply press Concentrator or Styling Pik into air outlet until it fits into place. To remove, allow dryer and attachment to cool, then gently pull away from dryer.
- The Finger Diffuser will soften the airflow from the hair dryer. To use, attach the Finger Diffuser to the air outlet. Allow diffuser fingers to run gently over the scalp while drying. To remove, allow dryer and attachment to cool, then gently pull away from dryer.
- Push the Cool Shot Button to set the style with cool air once you’ve achieved the desired style.
- When drying is complete, wait for the appliance to cool before storing. Do not wrap the cord around the dryer. Use the Hanging Ring. This keeps the cord from tangling and wearing prematurely.
CLEANING INSTRUCTIONS FOR LINT FILTER(S)
- LINT FILTERS DIFFER FROM DRYER TO DRYER. Some dryers have a filter inside the Removable End Cap as well as an internal filter inside the air intake. Others have only an internal lint filter inside the air intake grill.
- CLEAN THE LINT FILTER DAILY. This will extend the life of your dryer and prevent it from overheating and shutting off.
- Unplug the appliance from the power source. Remove the end cap by rotating it counterclockwise until it detaches from the dryer. (NOTE: The end cap may hinge downward or upward instead of rotating and may not be completely removable from the dryer.)
- Remove dust and lint from the internal lint filter using a brush, fingers or a vacuum cleaner.
- Your dryer may also have a lint filter attached to the Removable End Cap. If it does, clean that filter in the same manner, removing dust and lint from both the inside and outside of the filter.
- To replace the end cap, align the end cap’s tabs with the indentations inside the back grill of the hair dryer. Rotate the end cap clockwise until it locks into place
FAQs
How many heat settings does the Hot Tools HT7015D hair dryer have?
The Hot Tools HT7015D Turbo Ceramic Hair Dryer offers three heat settings, allowing you to choose the right temperature for your hair type and styling needs.
What is the maximum airflow speed of this hair dryer?
This hair dryer provides a powerful airflow with a maximum speed of 50 MPH (80.5 KPH), helping you dry your hair quickly and efficiently.
Is the Hot Tools HT7015D suitable for all hair types?
Yes, this hair dryer is designed to be versatile and can be used on all hair types, including fine, thick, curly, and straight hair.
Does it come with a diffuser attachment?
Yes, the Hot Tools HT7015D Turbo Ceramic Hair Dryer includes a diffuser attachment that helps enhance natural curls and waves without causing frizz.
What is the benefit of using ceramic technology in a hair dryer?
Ceramic technology helps distribute heat evenly, reducing the risk of heat damage and creating a smoother, shinier finish for your hair.
Can I use this hair dryer for travel?
Yes, it's a compact and lightweight hair dryer, making it suitable for travel. It also features dual voltage for worldwide use.
Is there a cool shot button for setting the style?
Yes, the Hot Tools HT7015D hair dryer has a cool shot button that allows you to lock in your style and reduce frizz.
How long is the power cord of this hair dryer?
The hair dryer comes with a 9-foot (2.7 meters) professional-length cord for flexibility and ease of use.
Is it suitable for salon use?
Yes, this hair dryer is designed for professional use and can be used in salons and by hairstylists.
Can I remove the filter for cleaning?
Yes, the removable lint filter makes it easy to clean and maintain the hair dryer for optimal performance.
What is the wattage of the Hot Tools HT7015D hair dryer?
This hair dryer operates at 1875 watts, providing powerful and efficient drying.
Is it suitable for drying extensions or wigs?
Yes, it's a versatile hair dryer that can be used for drying extensions, wigs, and various hair accessories.
Does it have a warranty?
The Hot Tools HT7015D Turbo Ceramic Hair Dryer typically comes with a limited warranty. Check with the manufacturer or retailer for warranty details.
Is the hair dryer relatively quiet during operation?
While it's not completely silent, it is designed to operate with minimal noise, ensuring a comfortable and quiet drying experience.
Can I purchase replacement attachments for this hair dryer?
Yes, replacement attachments such as concentrators and diffusers are typically available for purchase separately.
Is it safe to use on children's hair?
Yes, the Hot Tools HT7015D Turbo Ceramic Hair Dryer is safe for use on children's hair, but exercise caution and use it on the lowest heat setting to prevent overheating.
Download This PDF Link:Hot Tools HT7015D Turbo Ceramic Hair Dryer Instruction Manual