nordlux Oja 29 LED Light Instruction Manual
- June 13, 2024
- nordlux
Table of Contents
**nordlux Oja 29 LED Light Instruction Manual
**
Assembly Instruction
Removal Of Light Source
- Lift the frame from the housing by levering the housing slightly outwards with a screw driver.
- Remove the frame from the housing.
IP5X: Dust is prevented from entering the lamp in amounts that can cause damage to the function/safety of the lamp.
IPX4: Raindrops falling from any angle will not affect the function/safety of the lamp.
Class II: The lamp is double-
insulated and does not need to be connected to the yellow/green earth wire
The lamp is only suitable for
connecting directly to the mains
The mounting instruction must
not be discarded
IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries electrical installation work may only be carried out by a authorized electrical contractor. (*) Contact your local electricity authority for advice. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced
Disposal of waste equipment by users in private households in the European Union. This symbol indicates that this product must not be disposed of with your other household waste. Electrical and electronic equipment contain substances which may cause damage to human health and environment if not recycled correctly. It is your responsibility to hand over to a designated collection point for recycling of waste electrical and electronic equipment. When handing over for correct recycling you help to prevent these products straining nature and environment unnecessarily and to protect human health. For more information regarding correct disposal, please contact your local city office, your household waste disposal service or the store where you purchased this product.
For indoor use only.
General maintenance: Use a
soft, dry cloth for dusting, and a soft, damp cloth to gently remove grease or
similar stains. Never use any detergents or chemical reagents. Do not switch
on the lamp before all the water has evaporated. Specifically for mouth-blown
glass: Mouth-blown glass is formed manually. Because of this unique process,
bubbles may occur in the glass, just as the thickness of the glass may vary.
This is to be seen as a natural consequence of the manual process and is what
gives mouth-blown glass its character and organic look. Always clean mouth-
blown glass when the glass is cold.
This product contains a light source of energy efficiency class .D
Nordlux A/S · Østre Havnegade 34 · DK-9000 Aalborg
