NAPOLEON DLKTLV62 Driftwood Log Placement User Manual
- June 13, 2024
- Napoleon
Table of Contents
DLKTLV62 Driftwood Log Placement
For Model TLV62
DLKTLV62 Driftwood Log Placement
WARNING
- Failure to position the logs in accordance with these diagrams or failure to use only logs specifically approved with this appliance may result in property damage or personal injury.
- Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since appliance may not function properly and delayed ignition may occur.
- The logs are fragile and should be handled with care.
PHAZER™ logs and glowing embers, exclusive to Napoleon, provide a unique and
realistic glowing effect that is different in every installation. Take the
time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours
will become more uniform as colour pigments burn in during
the heat-activated curing process.
note:
Log numbers are located on the bottom or back of the logs.
Ensure to separate the 2 locating brackets.
Once apart, using a pair of pliers bend the 10 locating tabs to 90°.
Starting on the left side of the unit. Remove the 6 screws from the media tray and burner. Place the left bracket on top of the media tray and burner securing it with the screws just removed. Repeat the process for the right side.
Ensure the mesh covers are secured back in place.
Burner Overview
-
Place Log #1 behind locating tabs #3 & 4. Ensure the log is against tabs.
-
Place Log #2 in front of locating tab #8 and the pilot light. Ensure the log is against the tab and pilot light.
-
Place Log #5 behind locating tabs #1 & 2. Ensure the curved side of the log is facing forward and is against the tabs.
-
With the charred side facing the burner, place Log #3 in front of tabs #6 & 7. Ensure the log is against tabs.
-
Place the charred end of Log #7 on top of the curved portion of Log #5 and rest the opposite end on Log #3.
Ensure the log does not impinge upon the flames after startup.
-
Place Log #6 behind locating tabs #5 & 10. Ensure the log is against the tabs.
-
With the charred side facing the burner, place the pointed end of Log #9 in front of locating tab #9. Rest the opposite end on Log #6.
**** Ensure that no logs are covering any burner ports. Also, ensure there is no impingement of the flame with the logs.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • 1(866)820-8686 • www.napoleon.com