Aeroforge C78001 Hold Open Rod Installation Guide
- June 3, 2024
- Aeroforge
Table of Contents
Aeroforge C78001 Hold Open Rod Installation Guide
INSTALLATION INSTRUCTIONS SHEET
START FROM HERE Please Note:
- Make sure power is completely off at the fuse box.
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in clear area.
- Wear gloves at all times during this installation.
- Read instructions carefully before you start assembly.
- Keep this instruction sheet for future reference.
- Technical Support:1-844-628-8368
Please Note:
- All Matteo Lighting fixtures come with pre-wired module(s).
- Unless instructed to do so, please do not touch any part of the module(s) as any unnecessary contact with the module could cause permanent damage.
THIS LUMINAIRE MUST BE MOUNTED OR SUPPORTED IN A JUNCTION BOX CE LUMINAIRE DOIT ÊTRE MONTÉ OU SUPPORTÉ DANS UNE BOÎTE DE JONCTION
-
Ensure main supply is switched off.
-
Fit mounting bracket onto mounting surface with self-tapping screws (A).
-
Connect wires (B) according to color (White to White, Black to Black).
Connect all earth plug together onto the crossbar with green screw to tight. -
Fit ceiling plate (C) onto mounting bracket with nuts (D).
-
Install the bulbs (E) (not included) firmly into lampholders.
-
Fit lamp shade (F) into lampholders.
-
Reconnect power.
WARNING:
This fitting must be earthed.
Disconnect power and allow fitting to cool down before cleaning or changing
the lamp.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>