SOLAX POWER X 1 3.6kW Single Phase AC Coupled Charger User Guide

June 13, 2024
SOLAX POWER

SOLAX POWER X 1 3.6kW Single Phase AC Coupled Charger

SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
PRO

Packing List

SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
\(1\)

Note: Please refer to the appropriate instruction manual for the usage of optional accessories.

Inverter Installation

SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
\(2\)

Connections

Serial Port Connections

Ports Definition
Communication interface bewteen the inverter and Meter/Battery/DRM/485 are as follows with RJ45 connectors which should be inserted corresponing port in the inverter.SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
\(3\)

Prepare RJ45 connector and the communication cable, following the PIN definition and assembly order bellow, then insert the cable into the corresponding CT/Meter or BMS or DRM port of the inverter, and tighten the waterproof connector.SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
\(4\)

AC and Earth ConnectionSOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-
Charger- \(5\)

Battery Connection and Overview

Note: If you use the lead-acid battery, please refer to corresponding quick installation manual.

A:Power Connection Steps: Press down spring until it clicks audibly into place.SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
\(7\)

Overview for connection

  • After checking all connections is correct, turn on the external battery switch.
  • Turn on the grid switch.
  • Press the “Enter” key for five seconds to open the switch. The LED will be green and the screen will display the main interface.

Start Guide

SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger-
\(9\)

Firmware Upgrading

  1. Make sure the battery switch and the ACswitch is disconnected with grid. Unscrew the waterproof lid of Upgrade port by straight screwdriver as the picture shows.SOLAX-POWER-X-1-3-6kW-Single-Phase-AC-Coupled-Charger- \(10\)
  2. Insert U-disk with upgrade package* into the USB port on the bottom of the inverter. Then turn on AC switch the battery switch, the LCD will show picture as below.
  3. Press “OK” to confirm to update. After the upgrade is complete, please remember to turn off the battery switch and the AC switch , then pull off the U-disk, screw the waterproof lid.

Please contact our service support to get the update package,and extract it into your Udisk. Do not modify the program file name ! Or it may cause the inverter not work anymore!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SOLAX POWER User Manuals

Related Manuals