FRICOSMOS 476090 Food Warmer Lamp Instructions
- June 13, 2024
- FRICOSMOS
Table of Contents
FRICOSMOS 476090 Food Warmer Lamp
Product Information
- Model: Ref: 476090
- Version: Ed 2. 18/10/2019
- Website: www.fricosmos.com
- Email: info@fricosmos.com
- Telephone: (+34) 902 304 420
- Fax: (+34) 902 636 683
- Skype: fricosmos
Product Usage Instructions
CLEANING
- Disconnect the heat shade from the power source prior to cleaning and ensure the surface is cold.
- This unit can be cleaned with a damp sponge and mild soap.
- Rinse with clean water and wipe dry.
- Do not inmerse in water or other liquid.
- The heat lamp must not be cleaned by a water jet.
MAINTENANCE
Before performing any maintenance, make sure to disconnect the device from the
mains.
Follow these guidelines:
- Before any maintenance, disconnect the computer from the mains.
- If the cord is damaged it must be replaced by the manufacturer.
- The equipment should only be repaired by the manufacturer or a qualifi ed electrician.
- To replace a bulb, place the switch in the off position and allow the bulb and shade to cool completely.
- Bulbs have a threaded base, unscrew the bulb counterclockwise from the unit and replace with a new bulb.
Symbols
- Read carefully these instructions before use
- Indoor use only
- Hot surface
Handling or misuse of equipment eliminates mismo.
Fricosmos, S.A.
Polígono industrial nº 1, C/ Cámara de la Industria, 11A
28938 Móstoles (Madrid) – España
Tel. (+34) 902 304 420
Fax. (+34) 902 636 683
www.fricosmos.com
info@fricosmos.com
SAFETY
- All power must be disconnected at power source before any service procedure is performed.
- This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as drapes and other furnishings, away from appliance.
- Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is left unattended.
- Always disconnect appliance before cleaning, maintaining and ajusting it.
- Do not operate the appliance with a damaged cord or plug if the appliance malfunctions or has been dropped / damaged. Return appliance to an authorised service facility for examination, electrical or mechanical adjustment, or repair.
- Do not use outdoors. This appliance is not intended for wet or moist locations. Never locate appliance where it may fall into water.
- Avoid the use of extension cords. Do not run cord under carpeting, runners, or the like. Arrange cord away from traffi c area and where it will not create a trip hazard.
- This appliance has electrical parts. Do not use it in areas where gasoline, paint, or fl ammable liquids are used or stored.
- This equipment is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience or knowledge, unless they have had supervision or instruction concerning use of the appliance by a person
- responsible for their safety. Children must be supervised to assure that they do not play with the machine.
- This unit only suitable for R40 or BR40 type incandescent lamps. The lamp is excluded from the warranty.
INSTALATION
- Remove tape and protective packaging from all surfaces of unit.
- Make sure the installation site provides the proper installation clearances for the unit.
- Clean Heat Shade thoroughly before and after each use following the cleaning instructions provided in this manual.
- This product should only be connected to the mains electricity supply by a qualified electrician. Hardwire the Heat Shade into a suitable power suppply with correct voltage and suffi cient power capacity. Refer to the product label on the warmer for voltage and wattage requeriments.
- Drill a 11mm hole through mounting fixture.
- Pass wires from the shade through hole in fixture.
- Secure the shade to the fi xture with nut.
- The wires in this product are brown – live, blue – neutral and green / yellow for earth.
CARACTERISTIQUES TECHNIQUES TECHNICAL
References
Read User Manual Online (PDF format)
Loading......