14-RK10 RESKEY Control Ridge Keypad User Guide
- June 4, 2024
- RIDGE
Table of Contents
14-RK10 RESKEY Control Ridge Keypad
-
Unpack box and make sure you have all items shown here. (Screwdriver not shown.)
-
Remove single screw from bottom of unit and remove unit from mounting plate, pulling away from bottom end.
-
Remove screws from back of unit housing and carefully remove back cover to get access to battery holders.
-
Hold circuit board in place and insert batteries into battery holders, making sure to place in correct orientation.
-
Replace back cover of unit and secure with screws.
-
Install mounting plate where desired (hardware not included).(Can be done after programming.)
IMPORTANT: This unit is IP44-rated and has some protection from the elements, but it should be mounted in a covered location. Make sure to mount the unit away from metal objects and anything that will interfere with or block RF transmission. -
Attach unit and secure with screw.(Can be done after programming.)
433-MHz Programming
(For the Ridge 2.0 Transceiver 14-REC20 only)
Pair Keypad Unit with Ridge 2.0 Receiver (14-REC20)
On Ridge 2.0 Transceiver, press and hold the programming button for two
seconds and let go. LED will light. Perform the procedure below, and LED will
go out if the pairing is successful.
Add 433-MHz Access Code
Delete 433-MHz Access Code
Change 433-MHz Master Code
Add 433-MHz Limited-Use Code (Channel A Only)
Delete All 433-MHz Codes
300-MHz Programming
(For 300-MHz receivers including the Receiver 300 14-REC300)
IMPORTANT: For security reasons we recommend using custom DIP switch positions.
Add 300-MHz Access Code
Delete 300-MHz Access Code
Change 300-MHz Master Code
Delete All 300-MHz Codes
Unit will beep and flash and sound good tone when complete.
Additional information can be found atsecuritybrandsinc.com/ridge/
HELP NEED
Call 972-474-6390
Email
[email protected]
We are available Mon–Fri / 8am–5pm Central