GARMIN Constant Power Cable Instructions
- June 4, 2024
- Garmin
Table of Contents
GARMIN Constant Power Cable
Getting Started
WARNING
When installing the device in a vehicle, you must install the device
securely so it does not interfere with the vehicle operating controls, such as
the foot pedals, or the driver’s feet. Interference with the vehicle operating
controls or feet can result in an accident which could result in injury or
death.
CAUTION
Defer to your vehicle’s warranty provisions and owner’s instructions for
guidance on whether any 08D II connector product might void or alter your
vehicle’s warranty. Garmin is not responsible for any costs or expenses
associated with vehicle repairs or voided warranties. If you notice any change
in engine performance after connecting the device, disconnect the device
immediately and contact Garmin product support. Do not use the device if it
affects engine performance or acceleration in your particular make and model
of vehicle.
Installing the Device
-
Set the time switch (page 4).
-
Connect the device to the 08D II port in your vehicle.
The 08D II port is usually located under the dashboard on the driver’s side of the vehicle. The 080 II port location may vary depending on the make and model of your vehicle. See your vehicle owner’s manual for more information. -
Remove the protective film from one reclosable fastener, and press the reclosable fastener firmly onto the USB port end of the device for 10 seconds.
-
Clean the vehicle mounting surface using water or alcohol, and a lint-free cloth.
-
Allow the surface to dry completely.
-
Remove the protective film from a second reclosable fastener, and press it firmly onto the vehicle mounting surf ace for 1 O seconds.
-
Press the reclosable fastener on the device ag.ainst the reclosable fastener on the mounting surface to secure the device to the mounting location.
-
Connect the USB power cable from your Garmin Dash Cam™ device to a USB port on the Constant Power Cabte device.
Time Switch
The time switch CD sets the length of time the device continues to supply power after you exit the v,ehicl.e. The device reenables power when it detects motion, or when you reenter the vehicle.
If you want the device to remain off until you reenter the vehicle, you should select the 1 Om option. If you want the device to operate continuously while the vehicle is parked, you should select the 24h or oa option.
Status LED
The status LED shows the device status.
Specifications
© 2021 Garmin Ltd. or its subsidiaries Garmin’ and the Garmin logo are trademarks of Garmin ltd. or its subsidiaries, registered in the USA and other countries. Garmin Dash Cam”‘ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. Support.garmin.com
Printed in Taiwan
January 2021 190-02805-03_0A
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>