MONSTER 2MNHP2091 Wireless Headset User Manual
- June 13, 2024
- Monster
Table of Contents
2MNHP2091 Wireless Headset
MONSTER
User manual
Name: Wireless Headset
Model: 2MNHP2091, 2MNHP2091B0L2, 2MNHP2091G0L2
Bluetooth® Version: 5.3
Supported profiles: HSP/HFP/A2DP/AVRCP
Frequency response: 20Hz-20kHz
Impedance: 32Ω
Driver: Ø50mm Integrated Dynamic Driver
Sensitivity: 106±3dB at 1KHz
Effective range: up to 10 meters
Battery capacity: 1000mAh
Playing time: Up to 60hours
Charging time: Max. 2 hours
Charging port: Type-C™
Input voltage: DC 5V / 1A
Working temperature: 0~45℃
Storage temperature: -20~70℃
Wireless Headset Operation:
Power ON:
Press and hold the “MFB” button for 2 seconds.
Power OFF:
When the power is ON, press and hold the “MFB” for 5 seconds.
Bluetooth® Pairing:
Go to “Bluetooth” Setting on your Bluetooth® device (phone, tablet, etc.),
turn the Bluetooth® ON, on your device.
Press and hold the “MFB” for 5 seconds and then release it to enter pairing
mode. (The LED indicator will blink red and blue intermittently).
On your Bluetooth® device, select “Monster MAMBO M1” from the list of
available devices.
Dual Connection:
You can connect to two Bluetooth® transmitting devices (phone, tablet, etc.)
at the same time. Simply pause the
audio on the first device to play audio from the second device.
Aux input:
Plug the Aux 3.5mm connector of the included Aux to USB-C cable into a
compatible device (computer, phone,
etc.) and plug the USB-C side to your MAMBO M1 to use it as a wired headset.
Answer call:
Single press the “MFB” button to answer a call.
End call / Reject call:
Double press on the “MFB” button to end a call, or to reject an incoming call.
Voice assistant:
Double press on the “MFB” button. (Only when connected to a Bluetooth® device
that supports Voice Assistant.
This feature is not available duration a call.)
Play/Pause:
Single press the “MFB” button to play/pause music.
Previous Track:
Double press on the “-“ button.
Next Track:
Double press the “+” button.
Volume Up:
Single press “+” to increase the volume.
Volume Down:
Press “-” to decrease the volume.
Mute/Unmute microphone:
Press and hold the “+” button for 3S to mute/unmute the microphone. While the
headphones are muted, the Mic LED will be ON, red.
Charging the headset:
Connect the included charging cable to an appropriate power source and plug it
into the USB-C port on the headset to begin charging. The LED indicator will
be ON red while charging and will turn OFF once the battery reaches %100.
Quick Charge:
Charging the headset for 10min provides 2 hours of playtime.
Please Note:
This Bluetooth headphone shall be charged by the supplied charging unit only.
Caution: The batteries in this product are not replaceable. During use,
storage or transportation the battery should not be subjected to extremely low
temperatures, or low air pressure at high altitude. If the battery is exposed
to extremely high temperatures it could result in an explosion or the leaking
of flammable liquid or gas. Please take care when disposing of the unit;
disposal in a fire, oven, mechanically crushing or cutting machine could cause
an explosion.
Warning: Do not dispose of the unit in fire or water. Never attempt to
disassemble and reassemble. Waste electrical products should not be disposed
of with household waste, please recycle where facilities exist.
Check with your local authority for recycling advice. Keep your device and all
accessories out of the reach of children and animals. Small parts may cause
choking or serious injury if swallowed. Avoid exposing your device to very
cold or very hot temperatures (Below 0° or above 45° C).
Extreme temperatures can cause deforming of the device and reduce the charging
capacity and life of your device. Do not allow your device to get wet, liquids
can cause serious damage.
Do not handle your device with wet hands.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth® SIG, Inc., iPhone, iPad, and Mac is a trademark of Apple Inc.,
registered in the U.S. and other countries.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>