Roco 36089 TT Steam Locomotive BR 44 DR Instruction Manual
- June 13, 2024
- Roco
Table of Contents
36088 =
36089
Operating Manual
TT-model:
Steamlocomotive class 44, DR
Starting locomotive operation
Unwrap model: Take the loco carefully out of the packing with the help of the
foil (fig. 1).
Very important!
Before taking into service your model these bearings of the coupling rods must
be oiled as otherwise there would be the risk of bad running qualities of
dramage on he locomotive (see fig. 8). Operating instructions: Before use is
advisable to let the loco go around about 30 minutes forwards an 30 minutes
backwards without load, to obtain an optomal circuit and best tractive power.
The smallest radius this model should run is R11 (310 mm) . The model without
tubes protection pistons would run only if driven very carefully on R11. (fig.
3). Your locomotive will run smoothly on clean tracks only. For this purpose
we recommend using item no. 10002, ROCO track cleaning rubber, for removing
heavy dirt.
Fittings: In the enclosed accessory bag you will find small kits to be fitted
on your locomotive.
Please mount them cautiously. Attention!
Use glue only if indicated (fig. 2, fig. 3).
Running in digital mode:
First remove Tender body (fig. 9). Then remove the jumper from the interface.
Finally put the plug of the chip into the interface as shown in fig. 4.
Maintenance of the model
To enjoy your model for a long time, it is necesary to service it regulary (i.e. after it has been in operation for approximately 30 hours). Uncouple locomotive and tender first (fig. 5).
- Cleaning of wheel contacts: Wheel contacts easily get dirty on tracks which are not entirely clean. Use a small brush to remove dirt from spots marked in fig. 6.
- Lubrication: Apply tiny oil drops to spots marked in fig. 8. Prior to lubrication dismantle the tender body (fig. 9). We recommend using item no. 10906, ROCO oiler. For lubrication the gearparts (e.g. cogwheels, worm) we would recommended our ROCO special grease (item no. 10905). Attention: Please do not oil these parts when using our grease.
- Change of traction tyre: Remove bogie blind. Take out the wheel set and remove the traction tyre using a pin or a fine screwdriver (fig. 7). When pressing on the new traction tyre please avoid twisting it.
- Motor Changing: First remove tender body (fig. 9), and then the motor (fig. 9). Assembly: During assembly please take care of correct position of contacts (fig. 9).
- Don‘t throw your box in the dustbin. If your model is not in use this box will keep it safe. If kits are mounted on a wagon it will be slightly tight when placing it in the original box. This guarantees safe transport. It is therefore recommanded to cut out certain parts of the original box. To keep the model like the original, smaller parts (e.g. buffers) had been manufactured separately from the body and are not tightly fixed on it. Therefore they probably can get lost. In this case you certainly may reorder them but a complaint would not be acceptable.
Safety instructions:
This product may only be used in closed rooms.
Do not expose the model to direct sunlight, severe temperature fluctuations or
high air humidity.
https://www.roco.cc/de/aboutus/imprint/index.html
Modelleisenbahn GmbH A-5101 Bergheim PlainbachstraBe
Email: roco@roco.cc
Tel.: 00800 5762 6000
CATIDICID free of charge
International: +43 820 200 668 chargeable
**** 14+
Modelleisenbahn GmbH A-5101 Bergheim
Mobile max. 0,42€/min. 8036088-920 X/22
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>