MICROVISOR ME19R7041FS Center Filter Adapter User Guide
- June 13, 2024
- MICROVISOR
Table of Contents
ME19R7041FS Center Filter Adapter
MICROVISOR- Samsung Center Filter Adapter – for model #ME19R7041FS
-Included items: 2 Samsung adapters/ 2- 2” #8 screws/ instructions
Thank you purchasing the Samsung Center filter adapter! In this model of
Samsung microwave over the range, the center filter causes the need for our
mounting bracket
to sit 1” lower than the standard installation of our bracket, in order for
clearance to be provided for center filter removal. There are two pieces of
the adapters provided,
and they are identical. The adapters are designed so that 1 adapter will sit
in on each side of the pop out face filter. The adapters will line up on each
outside edge of the
MICROVISOR attaching bracket. A “helping set of hands”, will be useful during
this installation to assist in holding the brackets together while you are
placing the screws
into position. This installation should take less than 10 minutes.
Step #1: Read the main instructions for installing the MICROVISOR, it will
only take you’re a second and familiarize you with the new adapter
installation.
Step #2: Start by collecting the main attaching bracket and the 1 adapter
piece. It is best to install one side at a time, by placing the adapter with
largest flap side facing down onto the main bracket, so that the large
finished flap covers the seam between the mounting bracket and adapter piece.
-The adapter piece is the box tube with flap, sitting atop of the main bracket in this illustration.
-The bracket resembles the money clip mouth, sitting below the adapter bracket in this illustration.
See picture:
Step #3 :
Insert the first two inch screw, into the “left” most available hole on your
microwave chassis screw pattern with the main bracket and 1 adapter piece.
Insert screw through the bottom of the main attaching bracket, continue
passing through the new adapter into the factory hole. In some occurrences, a
little force may be necessary to drive new screw into hole, this is normal.
Tighten to just secure in place, do not fully tighten, as we need to adjust it
so as it will sit flush with the outside of edges of the microwave chassis.
While the bracket is suspended in place with the one adapter, move to the
other side to install adapter #2.
Step #4: Once the left screw is installed and the bracket is stable, insert
the second adapter and screw in the samefashion. Do not fully tighten.
Step #5: Once both adapters are
installed, and flush with outside edges of microwave unit frame tighten both
screws until seated firmly. You do not need to over tighten, just make sure to
tighten the screws firmly.
Completed installation look/ see picture:
Step #6: With
that completed, start cooking!!!!
If you need help, please visit our installation page for video installation of
this product: https://microvisorhood.com/how-to-install-instruction-video/
Or you can reach us at 201-388-4612
between the hours of Monday -Sunday/ 9-7pmEST/ Leave a message if our
switchboard is busy and we will get back to you within 12hours.