MICROVISOR PNM1871SMSS Removable Mini Hood Extension Instructions
- June 13, 2024
- MICROVISOR
Table of Contents
MICROVISOR PNM1871SMSS Removable Mini Hood Extension Instructions
Removable Mini Hood Extension for Microwave OTR
MICROVISOR- Microvisor GE Spacemaker Adapter/ Any unit requiring a bracket drop down for door/ hood clearance issue.
GE PNM1871SMSS , GE Profile Spacemaker 2.0 Cu. Ft
,
-Included Items: 1 full spacer adapter for GE/ 2- 2” #8 screws
Thank you purchasing the Microvisor GE Profile Adapter! In this model of GE
microwave over the range, in some models the curvature of the door causes the
need for our mounting bracket to sit 1” lower than the standard installation.
This is in order for clearance to be provided for normal door operation. There
is 1 full
adapter provided. The adapter will line up with outside edges of the
MICROVISOR attaching bracket when installed, and sit between main bracket and
bottom chassis of microwave unit. A “helping set of hands”, will be useful
during this installation to assist in holding the brackets together while you
are placing the screws into position. This installation should take less than
10 minutes.
Step #1: Read the main instructions for installing the MICROVISOR, it
will only take you’re a second and familiarize you with the new adapter
installation.
Step #2: Start by collecting the main attaching bracket, and adapter
piece. Start by placing the adapter with large flap side, facing down onto the
main bracket, so that the large finished flap covers the seam between the
mounting bracket and adapter piece.
-The adapter piece is the box tube with flap, sitting atop of the main bracket in this illustration.
-The bracket resembles the money clip mouth, sitting below the adapter bracket in this illustration.
Step #3: Insert the first two inch screw, into the “CENTER” hole on
your microwave chassis screw pattern (see original instructions on
installing mounting bracket).
Insert screw through the bottom of the main attaching bracket, continue
passing through the new adapter into the factory hole. In some occurrences, a
little forcemay be necessary to drive new screw into hole, this is normal. DO
NOT FULLY tighten at this time! Leave firm with some wiggle room, as we want
to perfectly
center the bracket and adapter on microwave. Now proceed to make sure that the
adapter and bracket are lined up with Microwave flush on both sides.
Step #4: Once the center screw is installed and the bracket is stable,
insert screws 2-5 where applicable in the screw pattern for the microwave unit
you have, do nottighten yet.
Step #5: Once that is completed, and the brackets are centered,
tighten center screw until seated firmly. Now move to the balance of the other
screws and tighten until firmly snug. You do not need to over tighten, just
make sure to tighten the screws firmly.
Completed look: (Illustration show is by example, and not depicting actual
curved door unit, clearance shown is what is needed)
Step #6: start cooking!!!!
If you need help, please visit our installation page for video installation of
this product: https://microvisorhood.com/how-to-install-instruction-video/
Or you can reach us at 201-388-4612
between the hours of Monday -Sunday/ 9-7pmEST/ Leave a message if our
switchboard is busy and we will get back to you within 12hours