Elna 202-001-014 Convertible Free Motion Quilting Foot Set Instructions
- June 13, 2024
- Elna
Table of Contents
Elna 202-001-014 Convertible Free Motion Quilting Foot Set
INSTRUCTION
CONVERTIBLE FREE MOTION QUILTING FOOT SET
Ref: 202-001-014
This set includes a foot holder and three feet:
- Closed-toe foot (shown with foot holder)
- Open-toe foot
- Clear view foot
Attaching the foot holder:
Remove the foot holder and attach the free motion quilting foot holder. Make
sure that the needle enters the center of the hole in the foot.
Changing the foot:
Raise the presser bar and turn the round nut (A) to bring the foot to the
lowest position. Remove the setscrew (B) and remove the foot. Attach the
desired foot and secure it with the setscrew.
Adjusting the height of the foot
Lower the presser bar. (On embroidery machines, turn the hand wheel to bring
the presser bar to the lowest position). Adjust the height of the foot by
turning the round nut (A) until the bottom of the foot barely touches the top
of the quilt layers.
MACHINE SETTINGS
- Stitch: Straight Stitch (Center needle position only) Thread tension: Auto or 2-5
- Feed dog: Lowered
Note:
The clear view foot can be used for zigzag stitches. Sew at medium speed while
guiding the quilt layers with your hands. Move the quilt layers 3 mm (1/8”) or
less per stitch.
Caution:
Do not select any pattern other than the straight stitch with center needle
position when the closed-toe foot or open-toe foot is attached. Do not turn
the hand wheel when the foot is raised.
Note:
Use the optional Bobbin Holder for Free Quilting with this foot set.
Elna International Corp. SA / 17.03.2022
Elna International Corp. SA / 17.03.2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>