elna 202-090-205 Ribbon-Sequin Foot Instructions
- June 13, 2024
- Elna
Table of Contents
elna 202-090-205 Ribbon-Sequin Foot
It is so much easier to attach ribbons and even sequins with the help of our ribbon/sequin foot.
This foot is designed with guides through which ribbons or strung sequins can be inserted, allowing them to feed through evenly as you sew.
Caution
Make sure to press the Lockout key when replacing the foot or attaching a binder.
For models without the Lockout key, turn the power switch off when attaching and detaching the foot and binder.
Please refer to your machine’s instruction manual for accessory attachment and removal information.
Machine Settings
Stitch pattern: Zigzag stitch
Stitch length: from 2 to 4
Stitch width: from 3-6 (according to ribbon or sequin)
Thread tension: adjust according to your envy
To Detach
Press the lever of the foot holder while pushing up and holding the foot lifter at the highest position to detach the foot.
To sew
- Pass the ribbon through the guide as illustrated according to the ribbon width.
Guide bar
* There are 4 ways to guide ribbons
1. Up to 4 mm
2. 5-6 mm
3. 7 mm
4. 8-10 mm
-
Do not turn the screw 2. Pull 2 – 3 cm (1’’) of the ribbon under the guide bar to the rear and under the foot.
- Pierce the cloth with the needles and start sewing.
- When guiding the ribbon as in 3, hold the ribbon slightly upward to guide it through the upper part of the opening.
Secure the stitch by sewing locking stitches at the beginning and the end.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>