ELRO HE844 Remote Control Instruction Manual
- June 13, 2024
- ELRO
Table of Contents
ELRO HE844 Remote Control
Specifications:
Remote control battery: 12V, type
CR 23A (incl.).
Channels: 4
Preparation for use
a Remove the plastic and insert the battery.
Linking your transmitter (HE844 (A)) to a receiver
a Set the dip switch in the correct protocol position, this causes the system to become compatible with other systems. Attention: only one switch should be set to ON. 1 is standard protocol, 2 is HE300 series protocol, 3 is AB600 series protocol, 4 combined systems: in this position all available protocols will be sent.
Switch your receiver in the linking mode, follow the manual of the receiver.
b Press on a button on the left side that you want to link (1, 2, 3, 4).
With this the LED of the receiver is off.
Operating a receiver
a Press the left and right buttons (1, 2, 3, 4) to switch on and off all receivers separately. Press on”l”and”O”buttons on the master (works only with HE800 series) to switch on and off all receivers at once.
(Optional) Operating a dimmer receiver
a Press on the “l” button to turn on the dimmer on the last set dim
level.
b Press on”0″to turn off the dimmer.
c When the dimmer is turned on: briefly press on”l”to dim the light;
Press on “I” again to stop the dimming.
Disconnecting a link
Switch your receiver in the linking mode, follow the manual of the receiver.
a Press on a button on the right side that you want to unlink (1, 2, 3,
4). With this the LED of the receiver is off.
Document of conformity
For the document of conformity go to www.elro.eu or scan
the QR code
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>